Abstract:This paper strives to derive the analytical solutions for the dynamic analysis of stepped multi-span rotor system, where the rotating shaft's internal damping effect is also considered. Specifically, the steady-state whirl analysis and free vibration analysis is given herein. For the steady-state whirl analysis, firstly, the stepped shaft is spilt to several uniform segments and their governing equations are established by Hamilton principle. Subsequently, by applying variable separation method and Laplace transform method to each segment's governing equation, their steady-state responses in terms of determinate interpolation functions multiplied by unknown boundary constants are derived. Then based on the transfer matrix method, each segment's boundary constants are determined with consideration of the compatibility conditions of each two adjacent segments and the end boundary conditions. For the free vibration analysis, one only need to remove the forced term in the steady-state form of transfer matrix and the rotor's characteristic equation will be obtained. Through the theoretical derivation, it is found that this analytical approach can be generalized to any isotropic elastic boundary conditions. To validate the proposed method, two case studies are proposed, where the finite element method is used as benchmark method. For the first one, the influence of internal damping on a uniform rotor's damped whirl characteristics and its stability is analyzed. The damped whirl characteristics analysis reveals that viscous internal damping result in the destabilization of forward modes as long as the spinning speed becomes higher than the critical speed. This phenomenon is also demonstrated by the time responses analysis. For the second one, the dynamic responses of a two-span three steps rotor-bearing system with isotropic viscoelastic boundary conditions are determined. All of simulated results show a great agreement between analytical results and FEM results.

The Analytical Solution and the Existence Condition of Dry Friction Backward Whirl in Rotor-to-Stator Contact Systems

Analysis of Reverse Whirl Characteristics of a Rub-Impact Rotor System

Rubbing phenomena in rotor–stator contact

DYNAMIC BEHAVIOUR OF A ROTOR PARTIALLY FILLED WITH FLUID IN THE UNSTABLE REGION

ANALYSIS OF THE MULTIPLE-SOLUTION RESPONSE OF A FLEXIBLE ROTOR SUPPORTED ON NON-LINEAR SQUEEZE FILM DAMPERS

Analysis of the dry whirl and dry whip response in a vertical active magnetic bearing drop test rig

Analytical modeling of stator vibration for surface mount permanent magnet brushless motors

Nonlinear dynamics of a rotor–stator system with contacts

Dynamic and Thermal Investigations of the Forward Dry-Friction Whirl/Whip of a Vertical Rotor-AMB System During Touchdowns

ROTORDYNAMIC STABILITY EVALUATION WITH CONSTRUCTED FORWARD WHIRL SIGNALS BASED ON FULL SPECTRUM TECHNIQUE: NUMERICAL AND EXPERIMENTAL INVESTIGATION

Predicting the Frequency of the Rotor Whirl Excited by Semi-Floating Ring Bearing

On the Bifurcation and Stability of Periodic Motion of the Rotor-Bearing System with Rub-Impact and Oil Whirl

Analysis of Nonlinear Vibration Characteristics and Whirl Behavior of Dual-Rotor Systems with Inter-Shaft Rub Impact

Lubrication and stability analysis of nonlinear rotor-bearing system

Nonlinear Vibration Induced by the Water-Film Whirl and Whip in a Sliding Bearing Rotor System

Analytical approach to the stepped multi-span rotor-bearing system with isotropic elastic boundary conditions

Radial and Torsional Vibration Characteristics of A Rub Rotor

Dynamic analysis of slant cracked rotor system considering nonlinear oil film force

Whirl dynamics of an axially functionally graded liquid-filled rotor considering shear deformation and rotary inertia

Nonlinear Dynamic Analysis of a Rigid Rotor Supported By a Spiral-Grooved Opposed-Hemisphere Gas Bearing

Study on the Semi-numerical and Semi-analytical Solutions of the Dynamics Equation of an Aero-engine Rotor System with ERSFD