Abstract:Polycrystalline Ni3Al-based superalloy with up to 70% <math>γ′</math> phase owns excellent strength at around 1100 °C. It has been successfully used as a substitute for turbine blade crown, which is one of the aircraft components working in the severest environment (i.e., sometimes nearly overheating). However, few studies concentrate on the coarsening resistance and phase thermal stability in this newly designed polycrystalline superalloy at the working temperature, hence, directional coarsening behavior of primary <math>γ′</math> <math>(γI′)</math> has remained restricted. This paper investigated directional coarsening behavior of <math>γI′</math> during aging treatment (1100 °C) after overheating at 1270 °C with furnace cooling (SFA), air cooling (SAA) and water cooling (SWA) respectively. It clearly showed that <math>γI′</math> grew into lamellar and gradually became irregular during the directional coarsening process. Moreover, its morphological combination mode was illustrated. Since parallel short lamellar <math>γI′</math> connected each other, long lamellar formed. When perpendicular long lamellar <math>γI′</math> connected each other, it became L-type or T-type, i.e., precursor of irregular <math>γI′</math>. The kinetics of directional coarsening regime of <math>γI′</math> was in line with the matrix-diffusion-controlled (MDC) theory according to the evaluation of <math>γI′</math> size. This was caused by higher migration of <math>γI′</math> interfaces than the diffusion of solute elements. It was also confirmed that driving force of directional coarsening mainly depended on the competition of elemental diffusion, lattice misfit distribution and <math>γ</math> channel distance.

Coarsening Behavior of Γ′ Particles in a Nickel-Base Superalloy

Influence of Cooling Rate on the Formation of Bimodal Microstructures in Nickel-Base Superalloys During Continuous Two-Step Aging

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Coarsening Kinetics of Γ′ Precipitates in a Re-containing Ni-based Single Crystal Superalloy During Long-Term Aging

Coarsening Transitional Kinetics of Γ′ Precipitates in a Nickel-Based Single Crystal Superalloy During Thermal Exposure

Growth and dissolution behavior and morphology evolution of γ' precipitates in GH4742 nickel-based superalloy

Coarsening Kinetics of γ′ Precipitates in Dendritic Regions of a Ni3Al Base Alloy

Influence of Initial Microstructure on the Γ′-Coarsening Behavior in a Corrosion-Resistant Ni-based Superalloy

Directional coarsening behavior of primary γ′ phase in Ni3Al-based superalloy during aging heat treatment

Coarsening kinetics of γ′ phase in isothermal aged high Al content Ni–17 at.% Al alloy

The Coarsening Behavior of Γ′ Phases in Ni-Al Binary Model Single Crystal Superalloy at 1000 °C

Oxidation Behavior and Mechanism of a Ni-based Single Crystal Superalloy with Single Α-Al2o3 Film at 1000 °C

Coarsening Kinetics of Intermetallic Precipitates in Ni75AlxV25−x Alloys

Influences of the Γ′ Phase on the Mechanical Properties of a Nickel-Based Single Crystal Superalloy

Aging process design based on the morphological evolution of γ′ precipitates in a 4th generation nickel-based single crystal superalloy

Coarsening Behavior of Γ′ Precipitates of Single Crystal Ni-based Superalloys During Long-Term Exposure

Dendritic Coarsening of Γ′ Phase in a Directionally Solidified Superalloy During 24,000h of Exposure at 1173K

Cellular Automata Simulation of Grain Growth of Powder Metallurgy Nickel-Based Superalloy

The Effect of Coarsening of Γ′ Precipitate on Creep Properties of Ni-based Single Crystal Superalloys During Long-Term Aging

Irregular Growth of the Γ′ Phase in a Ni-based Superalloys under Slow Cooling Rate

Precipitation behavior of γ′ phase with a multi-model morphology in the Ni-based superalloy GH4720Li during water quenching and subsequent artificial aging and related mechanisms