Abstract:<p>This paper experimentally investigates the effect of the yield strength of longitudinal steel bars and concrete compressive strength on the seismic performance of reinforced concrete (RC) bridge piers. Cyclic loading tests of ten large scale RC bridge piers (including five circular section and five rectangular section) with different longitudinal steel bars grades (varying among HRB335, HRB500E and HRB600) and concrete compressive strengths (i.e., 32.6 MPa and 48.2 MPa) were conducted. Two different steel replacement methods, i.e. equivalent volume and equivalent strength replacements, were adopted for comparison. The seismic performance indexes lateral bearing capacity, deformation capacity, hysteretic energy dissipation and residual displacement were compared and analyzed. The test results indicate that all RC bridge piers show typical flexural failure mode while circular piers show better deformability and hysteretic energy dissipation than rectangular piers. Replacing conventional steel bars HRB335 with same amount of high-strength longitudinal steel bars (HRB500E and HRB600) (i.e. equivalent volume replacement) will increase the lateral bearing capacity (as expected), the yield displacement and the total deformation. Due to the increase in yield displacement, the displacement ductility, the viscous damping ratio and the residual displacement will reduce to some extent. Still, the RC piers reinforced with high-strength steel bars (HSSB) show larger plastic deformation and hysteretic energy dissipation because of greater total deformation and bearing capacity. The transverse reinforcement configurations of circular section provide better restraint to the buckling of longitudinal steel bars than rectangular section, thereby RC bridge piers with circular section show better deformability and hysteretic energy dissipation than rectangular section. The increase in concrete compressive strength reduces the yield displacement, thus enhances the hysteretic energy dissipation and viscous damping ratio at same total deformation. It is worth noting that the effect of concrete compressive strength on the seismic performance of rectangular section is more remarkable than circular section. Replacing conventional longitudinal steel bars with reduced amounts of high-strength steel bars (i.e. equivalent strength replacement) provided comparable flexural strength and deformation capacity, but reducing the residual displacement and hysteretic energy dissipation.</p>

Experimental Study on Seismic Performance of Concrete-Filled Steel Bridge Piers

A Parametric Investigation on Ultra-low Cycle Fatigue Damage of Steel Bridge Piers under Horizontal Bi-directional Seismic Excitations

Analytical Calculation Method of Seismic Resistant Response for Posttensioned Precast Bridge Piers

Quasi-static Testing and Networked Pseudo-Dynamic Testing on Fiber Reinforced Plastic Retrofitted Reinforcement Concrete Short Columns of Bridge

Experimental Studies on Seismic Behavior of Steel Pile-to-Pile-Cap Connections

Remote Collaborative Pseudo-dynamic Testing of Carbon Fiber Reinforced Plastic Retrofitted Reinforcement Concrete Short Columns of Bridge

Seismic performance of concrete bridge piers reinforced by stainless steel bars: A quasi-static experimental study

Pseudo-Dynamic Sub-Structural Test for Circular Steel Bridge Pier with Partially Concrete-Filled

Seismic Performance of Concrete-Encased Cfst Piers: Experimental Study

Effect of reinforcement grade and concrete strength on seismic performance of reinforced concrete bridge piers

Experimental Study on the Seismic Performance of Round-Ended Hollow Piers

Experimental study on the seismic performance of concrete-filled steel tube columns with a multiple-chamber round-ended cross-section

Analysis of ultimate seismic performance of thin-walled concrete-filled steel tube bridge piers under dynamic load

Study on Seismic Performance Optimization of Assembly Concrete-Filled Steel Tubular (CFST)-Laced Piers

Experimental Research and Finite Element Analysis of Bridge Piers Failed in Flexure-Shear Modes

Experimental study on the seismic performance of self-centering bridge piers incorporating ECC and superelastic SMA bars in the plastic hinge regions

Seismic Performance of Concrete-Encased CFST Piers: Analysis

Pseudodynamic Test Research of Reinforced Concrete Bridge Column Pier

Experimental Study on Seismic Behavior of Concrete Filled Square Steel Tubular Columns to Low-Cycle Reversed Horizontal Load

Numerical Investigations on Seismic Behavior of Segmental Assembly of Concrete Filled Steel Tube Piers with External Replaceable Energy-Dissipating Links