Drawing process analysis of streamlined part by FEM simulation and optimization

吴会平,陈劫实,徐宗剑,舒世湘

DOI: https://doi.org/10.3969/j.issn.1001-4934.2008.04.003

2008-01-01

Abstract:The drawing process of a streamlined aluminum part was simulated by using the three-dimensional sheet metal forming analysis software Dynaform,and FLD figures of the punching process.The blank shape and process parameters were optimized to eliminate defects,and the process parameters' effects on the quality of the forming products were analyzed.The punching process for this aluminum part was determined.The produced parts had no forming defects,and had met the quality requirements.