Abstract:The quality and solidification structure of rotary products produced via horizontal centrifugal casting are contingent upon the thermal–fluid coupling dynamics of the molten metal. This study leverages numerical simulation to model the evolution of filling, solidification, and macrostructure in horizontal centrifugal casting. Utilizing the cellular automaton-finite element module and experiment, the study examines the development and mechanisms of the casting's macrostructure. Results indicate that centrifugal solidification exhibits a unidirectional progression from the exterior to the inside. The casting manifests a radial stratification of solidification structures, with an outer fine-grain zone emerging because of surface chilling. The substantial undercooling fosters the growth of fine grains into columnar crystals, culminating in the formation of an equiaxed crystal zone at the inner side. It is found that minor undercooling rate variations, along with flow-induced drag forces, Rayleigh–Bénard, and Bénard–Marangoni convection, contribute to the attenuation and potential disintegration of the columnar crystal growth front. The graphite spheres are affected by unidirectional solidification and flow state, showing a fine distribution of the outer spheres and an irregular sparse distribution of the inner side. These results lay a foundation for the influence of operating parameters on the quality of castings.

Microstructure Formation in Centrifugally Cast Al–Bi Alloys

Formation of core-type microstructure in Al–Bi monotectic alloys

Modeling and Simulation of the Microstructure Evolution During A Cooling of Immiscible Alloys in the Miscibility Gap

Evolution jof microstructure in centrifugal cast Al-Cu alloy

Phase separation and formation of core-type microstructure of Al–65.5 mass% Bi immiscible alloys

Numerical Simulation of Microstructure Evolution of Ti-6al-4v Alloy in Vertical Centrifugal Casting

A Full View of the Segregation Evolution in Al–Bi Immiscible Alloy

Centrifugally Cast Zn–27Al–xMg–ySi Alloys and Their in Situ (mg2si + Si)/ZA27 Composites

Segregation Driven by Collision and Coagulation of Minor Droplets in Al–Bi Immiscible Alloys under Aerodynamic Levitation Condition

Macrosegregation Driven by Movement of Minor Phase in (al0.345bi0.655)90sn10 Immiscible Alloy

The solidification microstructure of biomedical titanium alloys under the centrifugal force

Microstructure Evolution of Immiscible Alloys During Rapid Cooling Through Miscibility Gap

Coupling Simulation and Mechanism Analysis of Grain Formation and Growth in Horizontal Centrifugal Casting

Evolution of Solidification Microstructure of Centrifugal Cast Ti–6Al–4V Alloy

Observation of Bi Coarsening and Dissolution Behaviors in Melting Al–Bi Immiscible Alloy

Tailoring homogeneous immiscible alloy via magneto-Archimedes levitation

Graded Distribution of Microstructure in Centrifugal-Cast Al-CU Alloys

Direct Observation of the Segregation Driven by Bubble Evolution and Liquid Phase Separation in Al–10 Wt.% Bi Immiscible Alloy

Dynamic Behaviors of Minor Droplets and the Role of Bubbles in Phase-Separating AlBi Immiscible Alloy

Experimental and numerical studies on the influence of centrifugal casting parameters on the solidification structure of Al-Cu alloy

The Centrifugally Cast Zn-Al-Mg-Si Alloys and Their in Situ Surface Composites