Microstructure of warm rolling and pearlitic transformation of ultrafine-grained GCr15 steel
junjie sun,fuliang lian,hongji liu,tao jiang,shengwu guo,linxiu du,yongning liu
DOI: https://doi.org/10.1016/j.matchar.2014.07.011
IF: 4.537
2014-01-01
Materials Characterization
Abstract:Pearlitic transformation mechanisms have been investigated in ultra-fine grained GCr15 steel. The ultrafine-grained steel, whose grain size was less than 1μm, was prepared by thermo-mechanical treatment at 873K and then annealing at 923K for 2h. Pearlitic transformation was conducted by reheating the ultra-fine grained samples at 1073K and 1123K for different periods of time and then cooling in air. Scanning electron microscope observation shows that normal lamellar pearlite, instead of granular cementite and ferrite, cannot be formed when the grain size is approximately less than 4(±0.6)μm, which yields a critical grain size for normal lamellar pearlitic transformations in this chromium alloyed steel. The result confirms that grain size has a great influence on pearlitic transformation by increasing the diffusion rate of carbon atoms in the ultra-fine grained steel, and the addition of chromium element doesn't change this pearlitic phase transformation rule. Meanwhile, the grain growth rate is reduced by chromium alloying, which is beneficial to form fine grains during austenitizing, thus it facilitating pearlitic transformation by divorced eutectoid transformation. Moreover, chromium element can form a relatively high gradient in the frontier of the undissolved carbide, which promotes carbide formation in the frontier of the undissolved carbide, i.e., chromium promotes divorced eutectoid transformation.