Abstract:Phosphogypsum (PG) is a solid waste generated during the "wet phosphoric acid process". The phosphorus (P) impurities and low‐value‐added recycling products seriously constrain PG re‐utilization, which results in its massive accumulation and thus occupies large land areas and poses a severe pollution threat to the environment. In this study, by regulating gypsum crystal and P species in CaCl2‐HCl solutions under mild conditions, efficient removal of P impurities (leaching efficiency of 97.78%) and synchronous preparation of high‐strength α‐CaSO4·0.5H2O (α‐HH) (compressive strength of 35.2 MPa) from PG were achieved during the phase transition from CaSO4·2H2O (DH) to α‐HH, which was a reaction of DH dissolution, followed by α‐HH crystallization. The co‐crystalline P was fully released during the dissolution process, which was necessary to efficiently eliminate P impurities. HCl dissolved the released P and transformed them into the protonated specie (H3PO4) with less similarity to SO42−, which prevented the recombination of the released P with gypsum during the crystallization process. Furthermore, α‐HH morphology and size were controlled by seeding in the mixed solutions. The formation of regular large α‐HH crystals with a low specific surface area significantly weakened the surface adsorption of P in solutions and further increased the P leaching efficiency. More importantly, the large stumpy α‐HH was identified as high‐strength gypsum with high added value. This work would provide innovative guidance to efficiently remove impurities from gypsum and pioneer a cost‐effective approach for clean and high‐value utilization of industrial gypsum residues. This article is protected by copyright. All rights reserved

High efficient utilization of phosphogypsum:preparation and application of calcium sulfate whiskers

Preparation of α-hemihydrate gypsum whiskers from phosphogypsum using atmospheric pressure nitrate solution

Formation of Calcium Sulfate Whiskers from CaCO 3 -Bearing Desulfurization Gypsum

The Optimal Conditions of Preparation of Phosphogypsum-Based Calcium Sulfate Hemihydrate Whiskers by Hydrothermal Method Using Phosphogypsum

Study on the hydrothermal formation of calcium sulfate whiskers

Facile preparation of α-calcium sulfate hemihydrate whisker from by-product gypsum in chloride-free salt solution system

A Simple and Efficient Method for Preparing High-Purity α-CaSO4·0.5H2O Whiskers with Phosphogypsum

Study on performance and function mechanisms of whisker modified flue gas desulfurization (FGD) gypsum

Preparation of Calcium Sulfate Hemihydrate and Application in Polypropylene Composites

Efficient removal of impurities from phosphogypsum during preparation of α-hemihydrate gypsum

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions

Effect of Additives on Calcium Sulfate Hemihydrate Whiskers Morphology from Calcium Sulfate Dehydrate and Phosphogypsum

Direct transformation of FGD gypsum to calcium sulfate hemihydrate whiskers: Preparation, simulations, and process analysis

One-step synthesis of nanoscale anhydrous calcium sulfate whiskers: direct conversion of calcium carbonate by mixed acid with microemulsion method

The Generation Process, Impurity Removal and High-Value Utilization of Phosphogypsum Material

Rapid synthesis of alpha calcium sulfate hemihydrate whiskers in glycerol-water solution by using flue-gas-desulfurization gypsum solid waste

Efficient extraction of impurities from phosphogypsum during crystal regulation of α‐hemihydrate gypsum

A Feasible Route for Preparation of Calcium Sulfate Whiskers from FGD Gypsum via Filtrate Recycle under Hydro-Thermal Conditions

The study on the effect of flotation purification on the performance of α-hemihydrate gypsum prepared from phosphogypsum

Preparation of CSHW with Flue Gas Desulfurization Gypsum