Abstract:Partially deoxygenated pyrolysis oils, such as those produced by tail gas reactive pyrolysis (TGRP), show promise for use in biorefineries if they can integrate into standard refinery operations, one of which is distillation. A feasible method for modeling the process and for removing aqueous components will advance progress. This study investigated the potential of continuous flash distillation for fractionating partially deoxygenated bio-oil component chemicals benzene, toluene, and xylene (BTX), which are critical feedstocks for producing many refinery products. A model bio-oil mixture was used to evaluate process performance, and process conditions were investigated with respect to separation efficiency (temperature = 120, 130, and 140 °C; input flow rate = 2 or 3 mL min−1). Mean BTX yield (gout gin−1) for an oil flow rate of 2 mL min−1 ranged between 0.134 and 0.222 gout gin−1, while for 3 mL min−1 yields ranged from 0.135 to 0.400 gout gin−1. In all treatments, the measured amounts of BTX from model bio-oil were less than those from ASPEN simulations. From the distillates, aqueous fractions phase separated while sequestering acetic acid from the organics. Residence time within the drum was positively correlated with concentration of BTX in the distillates. At no point did solid residues form within the flash drum. When compared with analogous experiments at optimal conditions, BTX yields from real TGRP oil were comparable but less than the analogous model experiment. These results suggest that continuous, atmospheric pressure distillation of low-oxygen bio-oils can be used for separating commodity, refinery-grade chemicals such as BTX from biomass pyrolysis-derived bio-oils.

Separation of bio-oil by molecular distillation

Separation characteristics of biomass pyrolysis oil in molecular distillation

Pyrolysis Characteristics of Bio-Oil Fractions Separated by Molecular Distillation

Molecular Distillation Separation Characteristic of Bio-Oil under Different Pressures

Study on Purification of Pyrolytic Oil Derived from Pilot-scale Pyrolysis of Waste Tires in Multilevel Reactor

EXPERIMENTAL RESEARCH ON CORNCOB FAST PYROLYSIS FOR BIO-OIL IN A FLUIDIZED BED REACTOR

Separation of Acid Compounds for Refining Biomass Pyrolysis Oil

Separation and Characterization of Pyrolytic Lignins from the Heavy Fraction of Bio-Oil by Molecular Distillation

Character and Composition Analysis of Distilling Fractions from Sewage Sludge Pyrolysis Oil

Fractionation of Bio-Oil Produced from Hydrothermal Liquefaction of Microalgae by Liquid-Liquid Extraction

Separation, purification and composition analysis of bio oil from hydrothermal liquefaction of microalgae

High-pressure reactive distillation of bio-oil for reduced polymerisation

Separation and Enrichment of Catechol and Sugars from Bio-oil Aqueous Phase

Properties of Bio-oil from Fast Pyrolysis of Rice Husk

Separation of BTX chemicals from biomass pyrolysis oils via continuous flash distillation

Condition optimization of simulated bio-oil molecular distillation via response surface method

Esterification, Distillation, and Chemical Characterization of Bio-Oil and Its Fractions

Further separation, characterization, and upgrading for upper and bottom layers from phase separation of biomass pyrolysis oils

Full Temperature Range Study of Rice Husk Bio-Oil Distillation: Distillation Characteristics and Product Distribution

Characterization of column chromatography separated bio-oil obtained from hydrothermal liquefaction of Spirulina

Properties of Bio-Oil from Alga Fast Pyrolysis