Fractionation of Bio-Oil Produced from Hydrothermal Liquefaction of Microalgae by Liquid-Liquid Extraction

Hu-Sheng Hu,Yu-Long Wu,Ming-De Yang
DOI: https://doi.org/10.1016/j.biombioe.2017.10.033
2018-01-01
Abstract:Fractionation of bio-oil is in favor of upgrading bio-oil to transport fuel or chemicals. The microalgae Dunaliella tertiolecta was hydrothermally liquefied to form a bio-oil, which was split into two layers during cooling: the lower layer contained organics with relatively high molar mass from 78 to 389 g mol(-1), while the super layer with relatively low molar mass from 44 to 121 g mol(-1). The lower layer of hydrothermally liquefaction (HTL) bio-oil was further fractionated into ethanol phase (oil 1) and dichloromethane phase (oil 2), and the super layer yielded 1 or 3-4 fractions of extracts (oil 3) via single-stage or multistage liquid-liquid extraction respectively. The compositions of each fraction were analyzed by GC-MS in detail. Dichloromethane, chloroform, cyclohexane, benzene, toluene, iso-octanol, petroleum ether, carbon tetrachloride, 1,1,1-trichloroethane, ethyl acetate were compared in terms of their extraction capabilities to organics of bio-oil. The results indicated the chloroform and dichloromethane have the highest comprehensive extraction capabilities. In multistage extraction, when dichloromethane was used as extractant, the extraction distribution ratio (calculated using COD, chemical oxygen demand) was 0.66 in first-stage, then sharply dropped with an increase in stage number, 2nd similar to 3rd stage extractions achieved the maximum extraction percentage (approximately 53%). That the optimum combination of chloroform, benzene and 1,1,1-trichloroethane fractionated the super layer of HTL bio-oil can obtain very low oxygen content fraction: hydrocarbons (purity of hydrocarbons: relative content 97.9%) from the 2nd stage of multistage extraction.
What problem does this paper attempt to address?