Abstract:Abstract A thick-walled cylindrical specimen containing an external circumferential groove was subjected to external pressure. To investigate the maximum pressure sustainable by the reduced wall thickness, strain gage measurements were taken during external pressurization tests. For comparison to experimental results, an elastic-plastic notch stress-strain analysis was conducted based on Neuber’s rule. The analysis utilized multiaxial elastic finite element results along with elastic-plastic tensile test data for the cylinder material. Based on experimental observations, it was necessary to supplement the approach with an additional relation between elastic and elastic-plastic multiaxial strains for the axisymmetric geometry under investigation. Assuming an invariant hoop to radial strain ratio rather than an invariant hoop to axial strain ratio provided better agreement with experimental results. It is demonstrated that the boundary conditions used to model the specimen had a substantial effect on the finite element results, even though the boundary was somewhat removed from the region of concentrated stress. Biaxial strain measurements are presented versus pressure over the elastic and into the plastic regime, and deformation plasticity theory was used to compute stress and radial strain components corresponding to measured strains. It is demonstrated that in order to apply a multiaxial Neuber’s rule to accurately estimate the elastic-plastic stress-strain response (using elastic stress concentration information and elastic-plastic material data), it is necessary to utilize an experimental observation that the ratio of the hoop to radial strain remains invariant from the elastic to the elastic-plastic regime. This differs from published assumptions about invariant hoop-to-axial strain ratios based on analysis of circumferentially grooved solid shafts. The predictions are accurate for moderate plastic strains, but correlation breaks down for bulk plastic deformation.

Stress and Strain Concentrations in an Elasto-Plastic Bar of Circular Cross-Section with Semicircular Groove

Stress and Strain Concentrations in an Elastic Bar of Circular Cross-Section with Semielliptic Groove Subjected to Tension

Stress and strain concentrations for the filleted shafts in tension

Stress and strain concentrations in finite-thickness rings under diametrically opposite external loads

DETERMINATION OF THE MATERIALS STRESS AND STRAIN RELA- TIONSHIP FROM THE TENSILE SMOOTH AND NOTCHED BARS

Influence of the Geometric Parameters of Slotted Bar on Stress Concentration Factor at Prefabricated V-shaped Groove Bottom of the Bar Surface

The Stress and Strain Concentrations of an Elliptical Hole in an Elastic Plate of Finite Thickness Subjected to Tensile Stress

The Stress and Strain Concentrations in Curved Beams of Finite Thickness with End Moments

The Stress and Strain Concentrations of Out-of-plane Bending Plate Containing a Circular Hole

Stress concentration numerical analysis of a panel with big grooves

Experimental Investigation on Strain Concentration in Composite Laminates with a Circular Hole

The Effect of Biaxial Load on Stress and Strain Concentrations in a Finite Thickness Elastic Plate Containing a Circular Hole

Strain Concentrations and Progressive Damage Analysis of Notched Composite Laminates

A Study of the Creep Stress and Strain Characteristics of Smooth and Notched Bars

The concentration of stress and strain in finite thickness elastic plate containing a circular hole

The Stress and Strain Concentrations Associated with Two Interacting Holes in A Finite Thickness Elastic Plate Subjected to Tensile Stress

The size effect on the concentration of stress and strain in finite thickness elastic plate containing a circular hole

Multiaxial Stress Concentration in an Externally Pressurized Cylinder With an External Circumferential Groove

A structural curve with reduced stress concentration and its elastic–plastic failure analysis

The Coupled Effects of Thickness and Distance Between Holes on Stress and Strain Concentrations of Uniaxially Loaded Tensile Plates

Analysis of Stress Concentration for Curvilinear Holes by Complex Variable Function Method