Abstract:OBJECTIVE:To compare the bonding durability of three different self-etch adhesives to primary enamel and dentin, and to investigate the effect of mild salivary contamination followed by air drying on the bonding durability.METHODS:Two hundred and forty enamel specimens were divided randomly into 16 groups (n=15/group)according to the adhesive system [self-etch adhesives: Clearfil SE Bond(SE), AdperTM Easy One (EO), Scotchbond Universal (SBU); total-etch adhesive: AdperTM Single Bond Plus(SL)], contamination status (non-contaminated vs. salivary-contaminated) and storage condition (stored in distilled water for 24 h vs. aging mode 5 000 thermal cycles in 5 ℃ and 55 ℃). Two hundred and forty dentin specimens were assigned in the same way. Shear bond strength for 12 specimens in each group were measured. The adhesive interface for the residual specimens in each group was observed by scanning electron microscopy(SEM). Data were analyzed by three-way analysis of variance and Tukey test(P < 0.05).RESULTS:For primary enamel, total-etch adhesive showed higher initial shear bond strength values (28.92±1.83) MPa and shear bond strength values (27.27±3.03) MPa after thermal cycles compared with the other groups, and the difference between the groups was statistically significant (P < 0.01). Shear bond strength values of EO decreased significantly in salivary-treated groups, regardless of storage conditions, and the difference was statistically significant (P < 0.01). For primary dentin, shear bond strength values of EO decreased significantly in salivary-treated groups after 24 h (P < 0.01). After 5 000 thermal cycles, total-etch adhesive showed significantly lower shear bond strength values (14.31±1.97) MPa compared with the other groups, and the difference between the groups was statistically significant (P < 0.01), and shear bond strength values of EO were significantly lower than those in SE and SBU groups (P < 0.01), regardless of contamination status.CONCLUSION:Total-etch adhesive SL has better bonding durability to primary enamel. SE and SBU have better bonding durability to primary dentin and have a certain resistance to salivary contamination, while the bonding performance of EO is compromised greatly by mild salivary contamination followed by air drying.

Clinical Evaluation of a Self-Etching Bonding Agent in Preventive Resin Restoration

Durability of Four Composite Resin Cements Bonded to Dentin under Simulated Pulpal Pressure

Three Years Clinical Evaluation of Self-Eching Primer and Composite Resin on Posterior ClassⅠ Restorations

Effect of Captopril Pretreatment on the Dentin Bonding Durability of Self-Etch Adhesive.

Clinical Evaluation of Post- Operative Sensitivity of the Teeth Restored with Self- Eching Primer and Posterior Composite Resin

Clinical evaluation of pulp response of the teeth treated with self-etching dentin adhesive

Clinical Evaluation of Self-etching and Etching Adhesive on Non-carious Cervical Lesions at Two Years

Clinical application of self-etching adhesive in pit and fissure sealant of permanent molar

[Clinical Evaluation of a Two-Step Etch-and-rinse Adhesive and a One-Step Self-Etch Adhesive in Non-Carious Cervical Lesion].

Comparison of a recently developed nanofiller self-etching primer adhesive with other self-etching primers and conventional acid etching

Observed Clinical Effect of Fill with Clearfil SE-BOND Adhensives and the AP-X Composite Resin

Evaluation of Self-Adhesive Bonding Resin in Adhensiving Fiber-Post

Effects of pretreatment in post space on the bonding strength of self-adhesive resin cement to fiber posts

A Three-year Clinical Evaluation of Two Light Cured Materials for Preventing Technique

[Effects of Three Self-Etch Adhesives and Mild Salivary Contamination on the Bonding Durability of Deciduous Teeth].

Influence of Polishing Methods on the Bonding Effectiveness and Durability of Different Resin Cements to Dentin.

[Effects of Application Methods of Self-Etching Adhesives on Resin-Dentin Bonding].

Influence of the Dentin Smear Layer Trait on the Bond Strength of the Self-Adhesive Resin Cements

Comparative evaluation of bonding performance between universal and self-etch adhesives: In vitro study

Microleakage Evaluation of the Use of Different Bonding Agents Before Fissure Sealing

Determinations of the Bonding Strength with Pressure in the Same Direction for Two Enamel Adhesion Techniques: Self-Etching and All-Etching