Abstract:Abstract With the continuous development of the subway, the demand for its safety and stability is getting higher and higher. It is of great significance to accurately evaluate the fatigue life of the carbody to ensure the subway's safe operation. In this paper, the finite element model of a subway head carbody was established, and the fatigue strength of the welded structure on the carbody was evaluated based on Multi-axial stress. The local coordinate system was defined according to the geometrical characteristics of the welds. Local stresses perpendicular and parallel to the weld seam were obtained to calculate the stress ratio, stress range, and allowable stress value corresponding to the stress component. According to the joint fatigue resistance, the components of the degree of utilization and comprehensive degree of utilization are calculated to evaluate the structural fatigue strength under the survival rate of 97.5% and load cycles of 10 7 . The evaluation of the fatigue strength of the pivotal weld joints shows that the fatigue strength of the aluminum alloy carbody meets the design requirements, the weld of the carbody has a strong ability to resist fatigue damage. The fatigue strength of the weld is mainly affected by the normal stress component, while the shear stress has little effect on the fatigue strength of the structure. In addition, compared with the filleted weld joint and the butt-welded joint, the normal stress parallels to and perpendicular to the weld direction and shear stress have the greatest effect on the lap-welded joint. Meanwhile, the comprehensive degree of utilization of the lap-welded joint is the largest at 0.49. The introduction of multi-axial stress for the fatigue strength evaluation is beneficial when considering the material utilization degree in multiple structural directions. This research results provide a reference for fatigue strength evaluation of subway carbody's welded structure.

Analysis of Strength Match for T-Welded Joints in Al-Alloy Car Body Structure

Stiffness and strength numerical analysis of car body joint

Property Comparison of Laser Welded Butt Joint and T-joint of 6156-T4 Al Alloy

Experimental Study on Mechanical Behaviour of Friction Stir Welded Aluminium Alloy Butt Joints

Mechanical Characteristic and Stress-Strain Modelling of Friction Stir Welded 6061-T6 Aluminium Alloy Butt Joints

The robustness of Al-steel resistance spot welding process

Studies on a computational model and the stress field characteristics of weld-bonded joints for a car body steel sheet

INVESTIGATION ON THE FATIGUE STRENGTH OF ALUMINUM ALLOY NON-LOAD-CARRYING TIG FILLET WELDED CRUCIFORM JOINTS

Interfacial Microstructure and Mechanical Properties of Dissimilar Aluminum/steel Joint Fabricated Via Refilled Friction Stir Spot Welding

Finite Element Analysis of the Effect of Strength Match on Ductile Fracture Welded Pipe

Failure analysis of single-point butt clinched joint with dissimilar aluminium alloy sheets

Study on the Optimization of the Tensile Properties of an Al-Li Alloy Friction Stir-Welding T-Joint

Study on the J-Integral and Failure Assessment Line of Electron Beam Welded Thick TC4-DT Alloy Joints

Analysis of weld root fatigue cracking in load-carrying high-strength aluminum alloy cruciform joints

Microstructural and interface geometrical influence on the mechanical fatigue property of aluminum/high-strength steel lap joints using resistance element welding for lightweight vehicles: experimental and computational investigation

Fatigue Strength Evaluation of Welded Structure on Aluminum Alloy Car Body Based on Multi-Axial Stress

In Situ Observations of the Strain Competition Phenomenon in Aluminum Alloy Resistance Spot Welding Joints during Lap Shear Testing

Quantifying structure-property relationships during resistance spot welding of an aluminum 6061-T6 joint

Reliability Analysis and Evaluation of Automobile Welding Structure

A Fracture Mechanics-Based Optimal Fatigue Design Method Of Under-Matched Hsla Steel Butt-Welded Joints With Imperfections

Study on the Inconsistency in Mechanical Properties of 2219 Aluminium Alloy TIG-welded Joints