Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

EXPERIMENTAL INVESTIGATION OF HIGHLY EFFECTIVE COOLING WITH AN EVAPORATING ANNULAR FLOW IN A SMALL VERTICAL TUBE

Study of Refrigerated Mechanism of Evaporative of Air-Water Annular Two-Phase Flow in A Small Vertical Tube

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Numerical and Experimental Investigations of Electronic Evaporative Cooling Performance with a Coiled Channel

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

EXPERIMENTAL STUDY ON HEAT FLUX EFFECT ON EVAPORATION IN TWO DIMPLE-GROOVED TUBES

Experimental Investigation on Subcooled Boiling Heat Transfer in a Vertical Double-face Heated Narrow Annulus

Design and Exploration of Experimental Device for Heat Transfer of Low Temperature Fluid Outside the Tube

Experimental Study On Flow Heat Transfer In The Vertical Narrow Annuli

Eexperimental Study On Flow Evaporation Heat Transfer Characteristics Inside Horizontal Three-Dimensional Enhanced Tubes

Effect of evaporation temperature on boiling heat transfer in horizontal ribbed and embossing finned tube pool

An experimental study of annular film flow condensation in a micro-fin tube with high mass flux

Experimental Study of the Falling Film Evaporative Cooling on Horizontal Tubes Plates

THEORETICAL MODEL OF EVAPORATION HEAT TRANSFER BASED ON GAS-LIQUID ANNULAR FLOW OF HORIZONTAL MICROFIN TUBE

Investigations on Post-Dryout Heat Transfer in Bilaterally Heated Annular Channels

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

Experimental and Numerical Study on Liquid Film Cooling Performance under Heated Wall Condition

An Experimental Study on Flow Boiling Heat Transfer Outside Horizontal Enhanced Tubes

Experimental Investigation on Flow Condensation Heat Transfer in Hydrophobic Annular Metal-Foam Tube

Experimental Study on Convective Boiling Heat Transfer in Vertical Narrow-Gap Annular Tube