Abstract:As a result of conventional wire-forming processes, the residual stress distribution in wires is frequently unfavorable for subsequent forming processes such as bending operations. High tensile residual stresses typically occur in the near-surface region of the wires and can limit further application and processability of the semi-finished products. This paper presents an approach for tailoring the residual stress distribution by modifying the forming process, especially with regard to the die geometry and the influence of the drawing velocity as well as the wire temperature. The aim is to mitigate the near-surface tensile residual stresses induced by the drawing process. Preliminary studies have shown that modifications in the forming zone of the dies have a significant impact on the plastic strain and deformation direction, and the approach can be applied to effectively reduce the process-induced near-surface residual stress distributions without affecting the diameter of the product geometry. In this first approach, the process variant using three different drawing die geometries was established for the metastable austenitic stainless steel X5CrNi18-10 (1.4301) using slow (20 mm/s) and fast (2000 mm/s) drawing velocities. The residual stress depth distributions were determined by means of incremental hole drilling. Complementary X-ray stress analysis was carried out to analyze the phase-specific residual stresses since strain-induced martensitic transformations occurred close to the surface as a consequence of the shear deformation and the frictional loading. This paper describes the setup of the drawing tools as well as the results of the experimental tests.

Development of Progressive Die for Stainless Steel Thin-Shell Cylindrical Part

Optimum Design of Progressive Die Drawing Sequence Based on Finite Element Analysis

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Forming Limit of Sheet Metal in Cylindrical Deep Drawing with a Conical Die

Development of CAD/CAM System for Progressive Die of Lead Frame Based on SolidWorks

Research on compound forming process of cup-shaped part with inner gear

An Innovative Deep Drawing Process of Thin Curved Shells with Positive Local Bulging

A study of longitudinal cracking and the forming technology for deep-drawn austenitic stainless-steel cups

Analysis of Drawing Process for Cigarette Lighter Shell Based on Dynaform

Electromagnetic pulse-assisted incremental drawing of aluminum cylindrical cup

Production and application of precision stainless steel pipe diamond coating die

Research on Micro-Deep Drawing Process of Concial Part with Ultra-Thin Copper Foil Using Multi-Layered DLC Film-Coated Die

Residual Stress Engineering for Wire Drawing of Austenitic Stainless Steel X5CrNi18-10 by Variation in Die Geometries—Effect of Drawing Speed and Process Temperature

Study of Dieless Radial Spinning for Thick-Walled Cylindrical Parts With External Grooves

Die Design for Cylinder-shaped and Thin-walled Part

Design of the semi-closed die for shaping the thick coin-like carbon steel parts in a single operation

Improving parameters for achieving uniform cylindrical cup wall thickness in two-step deep drawing processes with SPCC sheet material

Research on a multi-step spinning process for manufacturing disc-like part with thickened rim

Research on Progressive Die Design for Asymmetric U-Shaped Contactor

The Processing Scheme of Welding Thin-walled Shell

Micro Deep Drawing of Micro Cups by Using Dlc Film Coated Blank Holders and Dies