Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Precision Tracking System with a Fast Steering Mirror in Vibration Environment

A Compact and High-Precision Method for Active Beam Stabilization System

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Stabilization of Laser Beam Position Based on a Closed-Loop Fast Steering Mirror System

Design and Servo Control for Precision Opto-Electronic Tracking Turntable

High Precision Vehicular Gyro-stabilized Tracking System

Predictive Control Method of Autonomous Vehicle Based on Tracking-error Model

Improvement of Response Speed Characteristics of Fast Steering Mirror based on Zero Phase Error Tracking Controller

System Identification and Tracking, Antidisturbance Composite Control Technology of Voice Coil Actuator Fast Steering Mirror

Design of Tracking Fast-Moving Target Depending on Rotating Mirror

Reinforcement Learning-Based Tracking Control under Stochastic Noise and Unmeasurable State for Tip–Tilt Mirror Systems

Fast and high-precision tracking technology for image-based closed-loop cascaded control system with a Risley prism and fast steering mirror

Research on Active Repetitive Control for Tracking Lissajous Scan Trajectories with Voice Coil Motors Actuated Fast Steering Mirror

Design and Control of Fast steering Mirror Based on Flexible Supports and Piezoelectric Ceramic Actuators

Nonsingular Terminal Sliding Mode Control of Voice Coil Actuator Fast Steering Mirror Based on Tracking Differentiator

Intelligent Hysteresis Compensation and Tracking Control of Piezoelectric Fast Steering Mirror

A Discrete Time-Varying Internal Model Based Approach for High Precision Tracking

Design of motion controller for precision stage based on tracking error predict

Precision Stage Motion Controller Based on a Vibration Model

Design and control of a fast steering mirror based on flexible supports and piezoelectric ceramic actuators

A Real-Time MEMS Mirror Based Beam Steering and Tracking System for Optical Wireless Communication