Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

High Precision Vehicular Gyro-stabilized Tracking System

A Compact and High-Precision Method for Active Beam Stabilization System

Design and Servo Control for Precision Opto-Electronic Tracking Turntable

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Performance test of optical and electronic image stabilizer for digital imaging system

Predictive Control Method of Autonomous Vehicle Based on Tracking-error Model

High-Precision Attitude Angle Measuring System Based on Talbot Interferometry

Enhancing Disturbances Rejection Ability of Four-axis Gyro Stabilized Platform with ESO

High-Precision Tracking of Free-Space Optical Communication System on Mobile Platforms

PaTAVTT: A Hardware-in-the-Loop Scaled Platform for Testing Autonomous Vehicle Trajectory Tracking

Robust stabilizer design for high-precision tracking of a linear gantry

Image stabilization technology based on inertial sensors and piezoelectric fast pendulum mirrors

Line-of-Sight Stabilization Enhancement With Hybrid Sensing in a Piezoelectric Mirror-Based Cubic Stewart Platform

Design And Control Of The Precise Tracking Bed Based On Complex Electromechanical Design Theory

Design and experiment of double-layer vibration isolation system for mobile vehicle-mounted optical platform

A Discrete Time-Varying Internal Model Based Approach for High Precision Tracking

A Low-Cost Positioning System For Parallel Tracking Applications Of Agricultural Vehicles By Using Kalman Filter

Dynamic Decoupling and Trajectory Tracking for Automated Vehicles Based on the Inverse System

A Tracking System Based on 2-DOF Motion Platform for Flight Simulator

Fuzzy disturbance observer-based modified variable gains super-twisting sliding mode composite control for a two-axis airborne optoelectronic stabilized platform

A multi-functional three-axis inertial stabilized platform aerial remote sensing system