Abstract:Nuclear thermalpropulsion reactor has attracted more and more attention because of its long service life, strong mobility and high concealment. However, in order to achieve higher mobility, nuclear thermalpropulsion reactor reduces its weight and does not have perfect radiation shielding measures, which will cause a lot of radiation to the external environment after operation. The radiation has an important impact on the application and development of nuclear thermal propulsion reactor. Therefore, it is necessary to study its radiation characteristics. This paper studies the radiation caused by the radioactive fission products produced after the operation of “Pluto” TORY ⅡC reactor published by the United States in the last century, ignoring the direct radiation of chain fission reaction, the radioactivity of component activation and the leakage of radioactive gas. Firstly in this paper, the burnup products of the reaction after 10 hours of full power operation were calculated by Monte Carlo method and the energy spectra of 106 radionuclides with high radioactivity were calculated, including Xray, gamma ray, bremsstrahlung and spontaneous fission gamma ray. Then the radiation field outside the reactor was calculated by pointkernel integral method. Because the pointkernel integral method has higher accuracy in calculating the simple structure, the reactor geometry was simplified in calculating the radiation field in this paper. The calculation results show that the reactor consumes 056% 235U after operation. The radioactivity increases gradually with time and finally reaches 1298×1021 Bq. Gamma radiation accounts for the main part. The maximum dose rate on the outer surface of TORY ⅡC shielding layer can reach 67185 Sv/h. Because the rear reflection layer is the thinnest and the side reflection layer is the thickest, the dose rate at the tail is the highest and the side dose rate is the lowest. At the same time, the calculated radiation field maintains a high dose rate in a large range. Therefore, this paper concludes that TORY ⅡC will produce a large amount of radiation after operation. Radiation shielding facilities must be installed to reduce the area of high radiation area, protect the environment and ensure personnel safety. At the same time, this paper calculates that the burnup products are regarded as uniform distribution and compares them with the previous accurate calculation results. It is found that there is little difference between the two calculation results in a far position. It can be inferred that when the distance is far enough, the two calculation results will be infinitely close. When the accuracy is not pursued, the burnup products can be regarded as uniform distribution to simplify the calculation and speed up the calculation time.

Study on Radiation of Water Tank During Reactor Shielding Water Leakage

Development of a Radiation Shielding Monte Carlo Code: RShieldMC

Monte Carlo method for analyzing research reactor shielding

Monte Carlo Simulation of Cherenkov Light Spot Produced by Underwater Radioactive Source

Linked calculation method based on next event estimation for directional shielding problems

Optimization Study on Shielding Design for Horizontal Ducts of China Advanced Research Reactor

A Study of the Impact of Cladding Materials on SCMR Neutronics Parameters

APPLICATION OF MCNP4C IN GAMMA SHIELDING DESIGN OF THE HTR-PM COMPARTMENTS AND ITS COMPARISON WITH QAD-CGA

Sensitivity of the neutron multiplication factor to water ingress into a spent fuel cask

Study on the Design and Experimental Verification of Multilayer Radiation Shield Against Mixed Neutrons and Γ-Rays

Monte Carlo Calculation of the Shielding of Mail Irradiation Systems

Simulating Radiation Shielding Effectiveness Against Three Neutron Sources

Study of a High Temperature–Resistant Shielding Material for the Shielding Doors of Nuclear Power Plants

Neutron shielding effects of spent fuel tank of high temperature reactor

A Coupled Deterministic and Monte-Carlo Method for Modeling and Simulation of Self-Powered Neutron Detector

Study on Composite Material for Shielding Mixed Neutron and $\Gamma$-Rays

Application of Monte Carlo and discrete ordinate coupling method to pressurized water reactor cavity radiation streaming calculation

Semi?empirical and Semi?quantitative Lightweight Shielding Design Method

Study of Self-Shielding Calculation with Temperature Distribution Applying Wavelets Scaling Function Expansion Continuous-Energy Resonance Method

Shielding Capability Research on Composite Base Materials in Hybrid Neutron-Gamma Mixed Radiation Fields

Study on External Environmental Radiation of Nuclear Thermal-propulsion Reactor