Abstract:Considering the inherent advantages of the Light Emitting Diode (LED) in the field of illumination, this work designs an intelligent supplementary lighting system using LED as the light source. Combining microcontroller and electronic circuit theory, the circuit is built with the microcontroller PIC16F873 as the core control chip. The system utilizes an external 220 V AC-20 V DC conversion power supply, hence operating on a 20 V DC power source. The system consists of four hardware parts: the onboard power supply uses TI-produced TPS54331 as the control chip to achieve voltage conversion; the external signals (flashing and burst flashing signals) are isolated from the microcontroller through an optocoupler circuit; the PWM pulses output from the microcontroller’s RC1/CCP2 pins drive the corresponding switching tubes to achieve the flashing function; the flashing synchronization signal is output externally after optocoupler isolation, and its synchronous output with the flashing signal is achieved through an optocoupler after LED conduction; the circuit is established using TI-produced differential bus transceiver SN65LBC184D to convert the external 485 differential signal to the level signal required by the microcontroller. In the experiment, after completing the hardware design, connecting the LED panel, and debugging the test program, it is found that the designed lighting system has a good supplementary lighting effect. According to the PWM output waveform, the flashing effect meets the design expectations. The Hadoop big data computing platform is introduced. Simulation testing reveals that under no backlight conditions, the system achieves an illumination intensity of around 20 klx at a distance of about 10 meters. With backlight conditions, the system maintains an illumination intensity of around 1.5 klx at a distance of about 10 meters. Further calculations are performed to analyze the variation in foot traffic within the test area’s illumination over 24 hours. The total illumination intensity during different time intervals is compiled, confirming that the system can autonomously adjust the illumination intensity of the area based on changes in foot traffic.

Study on the System of LED Die Bonder Based on PCI Bus

Monitor System of Energy-Feedback Electronic Load Based on CAN Bus and LabVIEW

Program Realization of High-speed and High-precision Surface Mounting System Based on Vision

Design of monitor and control system for a segment assembly test bed of shield machine

Research on a master-slave multi-microcomputers control system for hollow spindle fancy yarn spinning machine

Design of LED Production Equipment Molding Motion Controller Base on FPGA

Control Systerm for Machine Tool Spindle Based on PCI Bus

Design of Controlling Card Based on PCI Bus for Digital Tube Field Display

Design and Implementation of FPGA Based High-Speed Bus for Control System

Design and Realization of Remote Monitoring and Controlling System for Die Casting Workshop

The design of vision location system in automatic high-speed die bonder

Realization of A General Led Lighting System Based on A Novel Power Line Communication Technology

Automatic Monitoring and Controlling LED Energy Saving Lighting System Based on C8051F020 MCU

Research on an Integrative System for Automatic Dynamic Balancing Emendation Based on PCI Bus

Design of Portable LED Stage Lighting Control System

Implementation of an interface card of a position control system based on PCI bus

Design and Implementation of a Smart Networking Control System for LED Lighting Based on CAN.

Intelligent Light Emitting Diode Flashing Supplementary Lighting Control Design and Its Big Data Illumination Analysis

Design of New LED Curtain Wall Controller and Its Effect in Architectural Decoration

Design and Implementation of the Embed Computer Based on CompactPCI Express Bus

The Control System of LED Screen Based on a Single Chip Computer