Abstract:In structural deformation monitoring, traditional methods are mainly based on the deformation data measured at several individual points. As a result, only the discrete deformation, not the overall one, can be obtained, which hinders the researcher from a better and all-round understanding on the structural behavior. At the same time, the surrounding area around the measuring structure is usually complicated, which notably escalates the difficulty in accessing the deformation data. In dealing with the said issues, a digital image-based method is proposed for the overall structural deformation monitoring, utilizing the image perspective transformation and edge detection. Due to the limitation on camera sites, the lens is usually not orthogonal to the measuring structure. As a result, the obtained image cannot be used to extract the deformation data directly. Thus, the perspective transformation algorithm is used to obtain the orthogonal projection image of the test beam under the condition of inclined photography, which enables the direct extraction of deformation data from the original image. Meanwhile, edge detection operators are used to detect the edge of structure’s orthogonal projection image, to further characterize the key feature of structural deformation. Using the operator, the complete deformation data of structural edge are obtained by locating and calibrating the edge pixels. Based on the above, a series of load tests has been carried out using a steel–concrete composite beam to validate the proposed method, with the implementation of traditional dial deformation gauges. It has been found that the extracted edge lines have an obvious sawtooth effect due to the illumination environment. The sawtooth effect makes the extracted edge lines slightly fluctuate around the actual contour of the structure. On this end, the fitting method is applied to minimize the fluctuation and obtain the linear approximation of the actual deflection curve. The deformation data obtained by the proposed method have been compared with the one measured by the dial meters, indicating that the measurement error of the proposed method is less than 5%. However, since the overall deformation data are continuously measured by the proposed method, it can better reflect the overall deformation of the structure, and moreover the structural health state, when compared with the traditional “point” measurements.

Research on Technical Application of Deformation Observation in CCTV New Site Construction

Measurement on Soil Deformation and Numerical Simulation During Tunneling Process

Application of CCD Micro-Deformation Monitoring Technology to Slope Remote Monitoring

ANALYSIS METHOD OF PRE-SET CONSTRUCTION DEFORMATION VALUES FOR THE NEW CCTV HEADQUARTERS

DEFORMATION MODELING ANALYSIS REFLECTING THE INFLUENCE OF FOUNDATION IN NEW CCTV HEADQUARTERS

Development and Application of the High Precision Beidou Deformation Monitoring System in Shenzhen Ping'an Financial Center

Deformation monitoring of noncircular tunnels based on 3D laser scanning

ANALYSIS OF INTERNAL FORCE AND DEFORMATION FOR THE NEW CCTV HEADQUARTERS DURING THE CONSTRUCTION PROCESS

A Study on Tunnel Deformation Monitoring Based on BOTDA

Research on life cycle deformation monitoring system of Airport

Computer Vision‐based Monitoring of the 3‐D Structural Deformation of an Ancient Structure Induced by Shield Tunneling Construction

A New Approach for Cylindrical Steel Structure Deformation Monitoring by Dense Point Clouds

Full-Section Deformation Monitoring of High-Altitude Fault Tunnels Based on Three-Dimensional Laser Scanning Technology

An Overall Deformation Monitoring Method of Structure Based on Tracking Deformation Contour

A Case Study on the Application of 3D Scanning Technology in Deformation Monitoring of Slope Stabilization Structure

Large field-of-view deformation measurement for transmission tower based on close-range photogrammetry

The Deformation Observation Based on Tai’an Henderson Residential Areas and Forecast Analysis

Construction Monitoring for Stayed Cables Stretching of Vanke Center

Monitoring Dynamic Deformation of Building Using Unmanned Aerial Vehicle

On deformation supervision of office building of information center

Dynamic Inspection Technology of Tunnel Deformation Based on Onboard LIDAR