Topological Quantum Phase Transition and 3 D Texture Inversion in a Tunable Topological Insulator
Su-Yang Xu,Y. Xia,L. A. Wray,D. Qian,S. Jia,J. H. Dil,F. Meier,J. Osterwalder,B. Slomski,H. Lin,R. J. Cava,M. Z. Hasan
2011-01-01
Abstract:The recently discovered three dimensional or bulk topological insulators are expected to exhibit exotic quantum phenomena. It is believed that a trivial insulator can be twisted into a topological state by modulating the spin-orbit interaction or the crystal lattice via odd number of band inversions, driving the system through a topological quantum phase transition. By directly measuring the topological invariants (for method to directly measure ν0 of Fu-Kane, see Hsieh et.al., Science 323, 919 (2009) at http://www.sciencemag.org/content/323/5916/919.abstract) we report the observation of a topological phase transition in a tunable spin-orbit system BiTl(S1−δSeδ)2 (which is an analog of the most studied topological insulator Bi2Se3, see Xia et.al., Nature Phys. 5, 398 (2009) at http://www.nature.com/nphys/journal/v5/n6/full/nphys1294.html and spin-momentum locked topological-order at Hsieh et.al., Nature 460, 1101 (2009)) where the topological insulator formation process is visualized for the first time. In the topological state, vortex-like polarization states are observed to exhibit 3D vectorial textures, which collectively feature a chirality transition of its topological spin-textures as the spin-momentum locked (topologically ordered) electrons on the surface go through the zero carrier density point. Such phase transition and texture chirality inversion can be the physical basis for observing fractional charge (±e/2) and other related fractional topological phenomena. Topological insulators (TIs) in three dimensions are nonmagnetic insulators with novel surface states (SSs) that are a consequence of the nontrivial topology of electronic wavefunctions in the bulk of the materials (1-5 ). Their experimental discoveries first in Bi-Sb semiconductors (Hsieh et.al., 2007, 2008), then in Bi2Se3 (Xia et.al., 2008, 2009) and related materials have led to the exploration of topological quantum phenomena at modest temperatures and without the requirement of any applied magnetic field (6-16 ). The potential for the realization of fractional quasi-particles and exploitation of the role of spin-momentum locking leading to quantum phases (such as topological non-Abelian phases) in charge dynamics are some of the intriguing current theoretical proposals (17-24 ). Strong TIs are distinguished from ordinary insulators by a finite topological quantum number or an invariant (ν0) or equivalently an axion angle parameter (θ). The value of ν0 or θ depends on the parity eigenvalues of the wavefunctions in time reversal symmetric materials (1, 2 ), and can be determined from spin texture details of the spin-orbit surface states that form when the bulk is terminated as demonstrated by Hsieh et al. (6, 7 ). In particular, a ν0 = 1 = θ/π topology requires the terminated surface to have a Fermi surface (FS) that supports a nonzero Berry’s phase (an odd as opposed to an even multiple of π = θ =axion angle), which is not realizable in an ordinary spin-orbit or trivial (ν0 = 0 = θ) insulator. It is believed that a trivial insulator can be twisted into a ν0 = 1 = θ/π topological state by signaling the appearance of unusual spin vortex-like [or Skyrmionlike (1 )] arrangements via increasing spin-orbit interaction or by modulating the lattice parameters, thereby driving the system through a topological quantum phase transition (1, 2 ). However, the TIs Bi2X3 (X=Se,Te) cannot be tuned out from a trivial insulator version without a structural phase transition; in the Bi-Sb semiconductors, the topological phase transition is masked by an intervening band [the “H” band (1 )] and the lack of gating control necessary for its observation. We demonstrate the existence of a topological phase transition in TlBi(S1−δSeδ)2 which, as we show, is a fully tunable topological analog of Bi2Se3. By effectively varying the sulfur to selenium ratio (δ), both the spin-orbit strength and lattice parameters are effectively tuned (25 ). Because the topological order in TlBi(S1−δSeδ)2 originates from Bi and Se atoms and to illustrate an analogy with the known topological insulator Bi2Se3 (6, 8, 11 ) we rewrite the formulae as BiTl(S1−δSeδ)2. Figure 1A presents systematic photoemission measurements of electronic states that lie between a pair of time-reversal invariant points or Kramers’ points (Γ̄ and M̄) obtained for a series of compositions of the spin-orbit material BiTl(S1−δSeδ)2. As the selenium concentration is increased, the low-lying bands separated by a gap of energy 0.15eV at δ = 0.0 are observed to approach each other and the gap decreases to less than 0.05eV at δ = 0.4. Both bands demarcating the gap show three dimensional dispersion where binding energies vary with momentum perpendicular to the surface, kz, [as probed via varying incident photon energy (25 )] and roughly correspond to the expected position for the valence and conduction bands. The absence of SSs within the bulk gap suggests that the compound is topologically trivial (ν0 = 0 = θ) for composition range of δ = 0.0 and δ = 0.4. Starting from δ = 0.6, a linearly dispersive band connecting the bulk conduction and valence bands emerges which threads across the bulk band gap. Incident photon energy modulation studies support the assignment of these Dirac-like bands to be of surface origin (25 ). Moreover, while the band continua in the composition range of δ = 0.0 to δ = 0.4 are degenerate, the Dirac-like bands at δ = 0.6 and beyond are spin polarized (see Figs. 2, 3, and 4). The system enters a topologically non-trivial phase upon the occurrence of an electronic phase transition between δ = 0.4 and δ = 0.6 at temperatures below 15K. While the system approaches the transition from the conventional or no-surface-state side (δ = 0.4), both energy dispersion and FS mapping (Fig. 1, A and δ = 0.4) show that the spectral weight at the outer boundary of the bulk conduction band continuum which corresponds to the loci where the Dirac SSs would eventually develop becomes much more intense; however, that the surface remains gapped at δ = 0.4 suggests that the material is still on the trivial side. Finer control of bulk compositional variation does not allow locating a precise value for the transition; this could also be a consequence of an intrinsically broader topological transition. A critical signature of a topological phase transition is that the material turns into an indirect bulk band gap material as conjectured previously (1 ). As δ varies from 0.0 to 1.0 (Fig. 1C), the dispersion of the valence band evolves from a “Λ”-shape to an “M”-shape with a “dip” at the Γ̄ point (k = 0); the δ = 0.0 compound features a direct band gap in its bulk, whereas the δ = 1.0 indicates a slightly indirect gap. The overall experimental evolution of the spin-orbit groundstate is presented in Fig. 2A. Now we systematically study the end product of the transition BiTl(S0Se1)2 and explore its spin and polarization properties far away from the Dirac node where non-linear spinorbit terms are also important. Such terms correspond to analogs of cubic and higher order Dresselhaus effects arising from the symmetry of the crystal potential. Without these effects the SSs form a cone which is isotropic in momentum space (kx, ky) and hence generate a circular Fermi contour (2 ). Spins tangentially arranged on such a circular FS lead to a Berry’s phase of π, which is also a measure of the topological invariant and the axion angle (ν0 = 1 = θ/π) of the system (1, 4, 6 ). However, the details of the symmetry and bulk crystal potential can significantly deform the SSs from that of a circle. We explored the Fermi contour of BiTl(S0Se1)2 over a large energy range. This sample features an almost perfectly hexagonal FS at its native (as-grown) Fermi level (binding energy EB = 0.01eV), whereas the constant energy contour reverts to isotropic circular shapes when approaching the Dirac node (EB = 0.25eV and EB = 0.50eV). A more extreme example is the TI, ntype bulk doped Bi2Te3, which features a highly warped concave-in snowflake-shaped FS because of its large kF and a small band gap (25 ). In order to understand the relationship between these Dirac cone deformations and the topological invariants and axion angles (ν0 and θ), we utilized spin-resolved photoemission spectroscopy (spin-ARPES) (26, 27 ). Such spin-resolved study is also critical as Hall transport data are now possible that rely heavily on surface state topology and spin configuration data for interpretation (15 ). We have carried out spin polarization texture measurements over a large binding energy scale to capture the non-linear regime that can be accessed by gating for transport measurements. For simplicity, we show the results of the hexagonal FS above the Dirac node and one of the circular FSs below the Dirac node of BiTl(S0Se1)2 (see Fig. 2, B and E). Figure 2F shows the measured out-of-plane spin-polarization of cuts C and E (binding energy and momentum direction are defined in Fig. 2, D and E, respectively). No significant out-ofplane spin-polarization component is observed within the experimental resolution for cuts as these. The in-plane measurements, on the other hand, show large polarization amplitudes (Fig. 3A), suggesting that the spin texture is mostly two dimensional. Based on the data, we determine the direction of full 3D spin vectors following a two-step routine (25, 28 ). Because Pz = 0 (Fig. 2F), the out-of-plane polar angles are all close to 90 , so only in-plane azimuthal angles are shown in Fig. 3B. On the hexagonal Fermi contour which is located above the Dirac node (Fig. 3B), the spin vectors obtained from the polarization measurements show that the groundstate features a 2D inplane left-handed chirality spin vortex (a Skyrmion in momentum space, Fig. 3, B and C). The direction of the spin is roughly perpendicular to the momentum space track that connects the Γ̄ point and the momentum point location of the spin on the FS, rather than being tange