Abstract:Physically based constitutive equations incorporating the key microstructural mechanisms e.g. dislocations, grain size, etc, have been used widely to predict the stress-strain behaviour of alloys at plastic and viscoplastic conditions. This enables an accurate prediction of the formed geometry as well as the final underlying microstructures. However, these physically based constitutive equations have not been practically validated due to the lack of systematic experimental data at microscopic scale. This leads to a large number of unknown constants required to be determined through various optimization algorithms. The aim of this paper is to provide direct and systematic experimental data by revealing the dislocation (geometrically necessary one) density and grain size evolution of AA6082, which is a widely used high-strength aluminium alloy for automobile structural panels, as functions of strain, strain rate and temperature, and is the first-time using Electron Back Scattering Diffraction (EBSD) technique to visualize the microstructures during the hot deformation. The evolution of the dislocation accumulation during the hot tensile deformation at 300, 450, 530 degrees C using various strain rates (i.e. 1/s, 0.1/s, 0.01/s) was achieved. EBSD maps were analysed on samples submitted to a true strain level of similar to 0.1 and similar to 0.3 under each condition. These maps cover >3000 grains and enable to capture the statistical nature of the geometrically necessary dislocation densities during hot deformation. Despite the rapidly plateaued flow stress curves at high temperatures, a continuously increased average GND density was observed in AA6082 with the imposed true strain levels under all conditions. Dislocation channel structures were observed in the hot deformed samples. Dynamic recrystallization was also observed, which coupled with the GNDs and affected the hardening behaviour of the flow stress-strain curves. This work is the first study, using EBSD, to visualize the high temperature and high strain rate induced dislocation distributions over a relatively large area, providing valuable data that may be used for subsequently improving and calibrating the physically based material models.

Investigation of the Deformation Structure in an Aluminium Magnesium Alloy by High Angular Resolution Three-Dimensional X-Ray Diffraction

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Strain Distribution and Lattice Rotations During In-Situ Tension of Aluminum with a Transmodal Grain Structure

Anisotropic Deformation of Extruded Magnesium Alloy AZ31 under Uniaxial Compression: A Study with Simultaneous in Situ Synchrotron X-Ray Imaging and Diffraction

3Dxrd Measurements of Lattice Rotations in Tensile Deformed if Steel

Multiscale Measurements on Temperature-Dependent Deformation of A Textured Magnesium Alloy with Synchrotron X-Ray Imaging and Diffraction

Investigation of Grain Subdivision at Very Low Plastic Strains in A Magnesium Alloy

In-situ Analysis of Grain Rotation and Lattice Strain Within a Magnesium Polycrystal Based on Synchrotron Polychromatic X-ray Diffraction Technique: (I) Prior to Twin.

3D Grain Structure of an Extruded 6061 Al Alloy by Lab-Scale X-ray Diffraction Contrast Tomography (DCT)

Large Strain Deformation and Annealing of Aluminium

In Situ Monitoring of Dislocation, Twinning, and Detwinning Modes in an Extruded Magnesium Alloy under Cyclic Loading Conditions

Deformation Structure And Recrystallization In An Al Single Crystal Deformed In Tension

Deformation Dynamics in Pre-Twinned Mg-3Al-1Zn Alloy: A Synchrotron X-ray Study

Grain orientation dependence of microstructure in aluminium deformed in tension

Quantifying Geometrically Necessary Dislocation Density During Hot Deformation in AA6082 Al Alloy

Recrystallization of bulk nanostructured magnesium alloy AZ31 after severe plastic deformation: an in situ diffraction study

ANALYSIS OF DEFORMATION PROCESSES OF MAGNESIUM ALLOY AT ELEVATED TEMPERATURES BY ORIENTATION MAPPING

Electron Backscatter Diffraction Analysis of Recrystallized Grains Formed in Deformation Band in Aluminum Single Crystal

Grain Structure and Precipitate Variations in 7003-T6 Aluminum Alloys Associated with High Strain Rate Deformation

Effect of second-phase precipitates on deformation microstructure in AA2024 (Al–Cu–Mg): dislocation substructures and stored energy

In-situ SEM and EBSD Investigation of the Deformation Behavior of Extruded Mg-6Al-1Zn-1.1Sc Alloy