Abstract:Cold spraying is a potential alternative process to the current melting-based strategies of additive manufacturing technology that is expected to improve the mechanical properties significantly. However, the process, applied traditionally for coating rather than fabrication, lacks a method to ensure the manufacturing precision. The deposition profile, the key to this issue, is determined by the properties of the powder jet produced by the nozzle. Although significant efforts have been made to reduce the jet size and experimentally observe the deposition profile, a systematic study is required to gain a deep insight into the mechanism of the deposition profile and thus provide a solid base to optimize the process parameters. To address this issue, in this paper, a method is proposed to characterize the deposition profile quantitatively, and an integral analysis framework is established to connect all the procedures in the process, including gas flow, particle flight, particle impact, and particle deposition. In particular, a rule-based deposition model was developed using the impact physics as the foundation and the powder jet as the input. The structure of the powder jet, obtained from CFD analysis, was studied in detail to reveal the key factors and their distributions. In addition to aerodynamic drags, collision and reflection restrictions by the nozzle wall were found to largely contribute to the forming of the powder jet. The deposition profile obtained in the typical condition was characterized quantitatively, and the possible reason behind the inferior manufacturing precisions was uncovered. Moreover, the overlapping deposition was studied, revealing that adjacent depositions were uncoupled in the sense of dimensional profile. The influence of the injection size on the deposition profile was investigated and it was found that it is difficult to achieve both the manufacturing resolution and precision by adjusting this particular process parameter.

A Fundamental Model of Particle Deposition Incorporated in CFD Simulations of an Industrial Milk Spray Dryer

On the Applicability of the Coarse Grained Coupled CFD-DEM Model to Predict the Heat Transfer During the Fluidized Bed Drying of Pharmaceutical Granules

Numerical Model of Particle Deposition on Wet Fin Surfaces of Heat Exchanger under Dehumidifying Conditions

Highly Swirling Transient Flows in Spray Dryers and Consequent Effect on Modeling of Particle Deposition

Reduction of a model for single droplet drying and application to CFD of skim milk spray drying

Relationship between deposition properties and operating parameters for droplet onto surface in the atomization impinging spray

Numerical Model of Particle Deposition on Fin Surface of Heat Exchanger

Numerical Models For Viscoelastic Liquid Atomization Spray

Three-dimensional modelling of two-phase flow and transport in a pilot centrifugal spray dryer

Numerical Simulation Of Spray Evaporation Characteristics In Desulfuerization Reactor

Integral Numerical Modeling of the Deposition Profile of a Cold Spraying Process As an Additive Manufacturing Technology

Modeling and Simulation of the Evaporation and Drying of a Two Component Slurry Droplet

Developing an Empirical Equation for Modeling Particle Deposition Velocity Onto Inclined Surfaces in Indoor Environments

Novel CFD-DEM Model for Spouted Bed Drying Incorporating Intraparticle Heat and Mass Diffusion

Modeling and Simulation of Porosity in Spray Deposition

Effects of different nozzle materials on atomization results via CFD simulation

Numerical Prediction of Deposition in Two-Phase Flow in Vertical Pipes

Modeling and Simulation of a Co-current Rotary Dryer

Discrete Particle Simulation of Food Grain Drying in a Fluidised Bed

Recent initiatives in effective modeling of spray drying

Three-Dimensional Spray-Drying Model Based on Comprehensive Formulation of Drying Kinetics