Abstract:Phase field simulations incorporating contributions from chemical free energy and anisotropic interfacial energy are presented for the beta ->alpha transformation in Ti-6Al-4 V alloy to investigate the growth mechanism of alpha lamellae of various morphologies from undercooled beta matrix. The alpha colony close to realistic microstructure was generated by coupling the Thermo-Calc thermodynamic parameters of alpha and beta phases with the phase field governing equations. The simulations show that alpha lamellar side branches with feathery morphology can form under a certain combination of interfacial energy anisotropy and temperature. alpha lamellae tend to grow slowly at high heat treatment temperature and become wider and thicker as temperature increase from 800 to 900 degrees C provided that the interfacial energy anisotropy ratio k(x): k(y) was set as 0.1: 0.6. Besides, higher interfacial energy anisotropy can accelerate the formation of alpha lamellae, and the equilibrium shape of alpha lamellae changes from rod to plate as the interface energy anisotropy ratio kx: ky vary from 0.1: 0.4 to 0.1: 0.8 under 820. C. Experiments were conducted to study the alpha lamellar side branches in Ti-6Al-4 V (Ti-6.01Al-3.98 V, wt.%) and Ti-4211 (Ti-4.02Al-2.52V1.54Mo-1.03Fe, wt.%) alloys with lamellar microstructure. Electron backscatter diffraction (EBSD) results show that alpha lamellar side branches and their related lamellae share the same orientation. The predicted temperature range for alpha lamellar side branches formation under various interfacial energy anisotropy is consistent with experimental results. (C) 2021 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.

Transformation of the Θ-Phase in Mg-Li-Al Alloys: a Density Functional Theory Study

Phase transformations in an ultralight BCC Mg alloy during anisothermal ageing

Elucidation of formation and transformation mechanisms of Ca-rich Laves phase in Mg-Al-Ca-Mn alloys

Atomic-scale Mechanism of the Θ″ → Θ′ Phase Transformation in Al-Cu Alloys

Microstructure and Phase Transformation of Ni46Mn33Ga17Cu4−xZrx Alloys

Metastable state transformations of Al3Ti-base alloys during mechanical milling and subsequent annealing

Insight into the aging behavior of a novel Al-Li-Cu-Mg alloy

A new Al5Cu6(Li,Mg)2 cubic phase in an Al-Cu-Li-Mg-X alloy

Microstructure and phase transformation of as-cast and annealed Mg–4Zn–1Y alloy containing quasi-crystal phase

Formation mechanism of lamellae during ¡ transformation in polycrystalline dual-phase Ti alloys

Deformation behavior and phase transformation of a dual-phase Mg−8.9Li−2.7Al-0.85Si alloy under compression test at elevated temperatures

Effect of Icosahedral Phase on Crystallographic Texture and Mechanical Anisotropy of Mg–4%Li Based Alloys

Three-Dimensional Phase-Field Simulation and Experimental Validation of β-Mg17Al12 Phase Precipitation in Mg-Al-Based Alloys

Three-Dimensional Phase-Field Simulation and Experimental Validation of β -Mg 17 Al 12 Phase Precipitation in Mg-Al-Based Alloys

Influence of Mg content on ageing precipitation behavior of Al-Cu-Li-x alloys

Formation of Phases and Microstructures in Al-8Si Alloys with Different Mg Content

Phase-field Simulations of Dendrite Morphologies and Selected Evolution of Primary Α-Mg Phases During the Solidification of Mg-rich Mg–Al-based Alloys

First-Principles Investigations on Structural Stability, Elastic Properties and Electronic Structure of Mg32(Al,Zn)49 Phase and MgZn2 Phase

Ageing evolution process of the θ ′ -phase in Al-Si-Cu-Mg alloys: Atomic-scale observations and first-principles calculations

Enhancing Plasticity in BCC Mg-Li-Al Alloys Through Controlled Precipitation at Grain Boundaries

Evolution of Deformation Substructure and MgxZnyCaz Metastable Phase in Fine-Grained Mg Alloys