Abstract:ABSTRACTDeveloped more than 80 years ago, the design procedure of concrete filled steel tubes (CFST) has several limitations that can still be found in most current international design standards. The two main limitations that present themselves are the lack of ability to achieve material enhancement when using high strength materials and restrictions on the geometry of the steel tube thickness to the overall column diameter. This geometric limitation is placed on the design to ensure that the steel tube remains ‘compact’. In complying with these constraints it is assumed in the design equations that local buckling of the steel tube will not take place before the ultimate global buckling load is achieved.With the introduction of higher strength materials, specifically when dealing with steel, the strength increase leads to the design of sections with increased slenderness. As the section becomes more slender, the ability to maintain the compact section limitations in the design codes becomes increasingly difficult. This paper looks at an experimental study on very thin‐walled steel tubes filled with high‐strength concrete and how localised buckling affects their compressive capacity.Adopting a diameter to thickness ratio of 200, 24 circular tubes were constructed using a high‐strength cold‐formed steel sheet, with yield stresses above 500MPa and filled with 100MPa concrete. Employing both thin‐walled sections and high strength materials, the effects of localised buckling in these composite members when subjected to compression has been studied. The experimental programme explored four main conditions; when both the steel and concrete were loaded and bonded together, when the concrete core inside the CFST was loaded, when the steel tube in the CFST was loaded and when the concrete core without the steel tube was tested.By studying the failure modes of both the concrete and the steel tube when acting compositely and individually, the experimental work shows that there is valid evidence to support the theory that even when using high strength materials in slender sections, confinement to the concrete core is provided. Finally, the results of the experimental work have been compared to the compressive design capacities predicted by current international design codes, showing that these provisions are conservative.

Behavior of CFST Short Column and Beam with Initial Concrete Imperfection: Experiments

Seismic Behavior of Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns

Behaviour of CFST stub columns with initial concrete imperfection: Analysis and calculations

Effects of Core Concrete Initial Imperfection on Performance of Eccentrically Loaded Cfst Columns

Behaviour of Concrete-Filled Steel Tubes with Concrete Imperfection under Axial Tension

Structural performance of circular CFST columns with circumferential gap imperfections

Study on the Axial Compressive Capacity of CFST Columns with Gap Defects

Experimental Study on Axial Compressive Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Experiments on Special-Shaped CFST Stub Columns under Axial Compression

Experimental Study on Seismic Behavior of Concrete-Filled Steel Tube with Spherical-Cap Gap

Structural Behaviour of Concrete-Encased CFST Box Stub Columns under Axial Compression

Tests on elliptical concrete filled steel tubular (CFST) beams and columns

STUDY ON BEHAVIOR OF CONCRETE FILLED ELLIPTICAL STEEL TUBE MEMBERS PART I: SHORT AND LONG COLUMNS UNDER AXIAL COMPRESSION

Behavior of Circular-Steel-tube-confined Square CFST Short Columns under Axial Compression

Performance of Hexagonal CFST Members under Axial Compression and Bending

Concrete-filled steel tubes subjected to axial compression: Life-cycle based performance

Experimental Studies On The Strength With High Slenderness Ratio Concrete Filled Steel Tubular Columns

Behavior of concrete-filled T-shaped steel tubular beam-columns under biaxial compressive loads

08.17: Experimental Behaviour of High‐strength Thin‐walled Concrete Filled Steel Tubular Stub Columns

Experimental Behaviour of Concrete-Filled Steel Tubular Members under Lateral Shear Loads

Axial Compression Behavior of Elliptical Concrete-Filled Steel Tube Composite Short Columns with Encased Steel Considering Spherical-Cap Gap