Abstract:A laboratory study is presented for the dynamic behaviors of isotropic and anisotropic consolidated Hangzhou soft clay subjected to unidirectional and bidirectional exciting cyclic loading using GDS bidirectional dynamic testing system.It is observed that the cyclic strain amplitude and excess pore water pressure increase with the increase of radial cyclic stress ratio.Compared with the strain,excess pore water pressure increases more significantly.Under unidirectional cyclic loading,the excess pore water pressure amplitude decreases with the increase of initial shear stress.However,the effect of initial shear stress on excess pore water pressure is less distinctly under bidirectional cyclic loading.There is a threshold radial cyclic stress ratio under bidirectional cyclic loading.When the radial cyclic stress ratio is lower than it,bidirectional cyclic loading cannot accelerate the failure of clay.The turning strain of e d-lgN curve is defined as an alternative failure criterion for clay.A significant feature of this criterion is that it is not a constant value but approximately linearly increases as the radial cyclic stress ratio increases or the failure cycle decreases.The dynamic strength of soft clay degrades slowlywith the number of failure cycles under unidirectional cyclic loading.However,the dynamic strength degrades more rapidly under bidirectional cyclic loading.It also can be observed that the dynamic strength decreases significantly as radial cyclic stress ratio increases.This observation implies that for the stability problems of slopes involving seismic loading,the effect of radial cyclic stress on strength should also be considered.The strength determined in tests without considering the effect of radial cyclic stress is an unsafe estimation.

IMPROVEMENT ON THE ENVELOPE METHOD EVALUATING R-CURVE OF CERAMICS

Experimental Reasearch on Grinding Surface Waviness of Engineering Ceramics

Macro- and Meso-Scale Parametric Analysis of Egg-shaped Yield Surface of Structural Soil

RESEARCH ON PATTERN TRANSITION CURVES AND THE PARAMETERS IN STRESS-STRAIN RELATIONSHIP OF SOILS

Characterization of R-curve Behavior in Si3N4-based Ceramics

STUDY ON STRENGTH AND DEFORMATION BEHAVIORS OF SOFT CLAY UNDER BIDIRECTIONAL EXCITING CYCLIC LOADING

Cyclic shearing behavior of K0-consolidated day and its rheological simulation

A MECHANICS ANALYSIS OF STRENGTHENING-TOUGHENING DESIGN OF MULTILAYER STRUCTURE CERAMICS

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

EXPERIMENTAL RESEARCH ON CHANGING RULES OF DYNAMIC MODULUS AND DAMPING RATIO OF SATURATED SOFT CLAY UNDER BIDIRECTIONAL EXCITING CYCLIC LOADING

Study of Failure Criterion for Hangzhou Intact Soft Clay under Complex Stress Path

Master Curves for Poroelastic Spherical Indentation with Step Displacement Loading

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control

Analysis, Simulation and Experimental Study of the Tensile Stress Calibration of Ceramic Cylindrical Pressure Housings

On The Efficiency Of The "Effective Truncation Length" Of Indenter Tip In Mechanical Property Determination With Nanoindentation Tests

Analysis of Load-Displacement Curves of Ceramics Measured with Low-Load Vickers Hardness Test: Indentation Size Effect

On the Local Crack Resistance of Al2O3–TiC Composites Evaluated by Direct Indentation Method

Investigation of Micro-defects in Dental Ceramics and Damage Evolution

Weibull modulus of fracture strength of toughened ceramics subjected to small-scale contacts

R-curve Behavior of Indentation Cracks in Silicon Nitride Based Ceramic Composite

Experimental and Calculative Research on the Dynamic Bond Strength of the Interface Between Steel and Cement Mortar