Abstract:The fatigue property of riveted lap joint is greatly related to the riveting-induced residual stress, especially the stress distribution on the faying surface. However, an accurate study of the residual stress characteristics in the riveted sheet could be very difficult. In this paper, both numerical and experimental investigations were carried out on the stress/strain characteristics in riveted aircraft lap joints. A special specimen was designed for the test of strain variations on the faying surface of the sheet by microstrain gages. For the numerical simulation, the rivet squeezing process was analyzed using the explicit dynamic finite element (FE) method, whilst a general static FE analysis was employed for the elastic springback after the squeeze force was removed. A comparison of the strain variations between the experimental results and FE simulations shows a general good agreement, although there may be some difference for points measured near the hole surface. The FE analysis reveals that both compressive and tensile residual stresses could be introduced in the riveted sheet. Massive compressive residual stress can be created in the near-surface layer of the hole. However, the stress level is not always increased with increasing the squeeze force, and so is the improvement of fatigue life observed. Further study is still necessary to account for the fatigue life decreasing effect caused by a high squeeze force.

Research on Finite Element Analysis of Multi-rivet Lap Metallic Joints

Influence of Rivet Diameter and Pitch on the Fatigue Performance of Riveted Lap Joints Based on Stress Distribution Analysis

Investigation on the Residual Stresses and Fatigue Performance of Riveted Single Strap Butt Joints

Numerical Investigation on Optimizing Fatigue Life in a Lap Joint Structure

Elastic-plastic Analysis and Riveting Energy Control for Dual-Robot Pneumatic Riveting System

Study on Analysis and Prediction of Riveting Assembly Variation of Aircraft Fuselage Panel

Experimental and numerical studies of stress/strain characteristics in riveted aircraft lap joints

Experiment and Numerical Simulations of a Slug Rivet Installation Process Based on Different Modeling Methods

Effect of Riveting Angle and Direction on Fatigue Performance of Riveted Lap Joints

Residual stress and fatigue behavior of riveted lap joints with various riveting sequences, rivet patterns, and pitches

FE Analysis of Stress Concentrations in Composite Plates with Multiple Holes for Zigzag Multi-Fastened Joints

Research of Fretting Fatigue Characteristics of a Fiber Metal Laminate – A Steel Single-Lap Joint

Analysis of Residual Stresses Induced by Riveting Process and Fatigue Life Prediction

Stress, damage, and fatigue performance analysis of CFRP/Al double-sided countersunk riveted joints with variable rivet-hole clearance

Optimizing riveting process parameters in a lap joint in aircraft fuselage using taguchi method

Fatigue behaviour analysis of aluminium alloy riveted single-shear lap joints

Detail Stress Analysis and Fatigue Crack Initiation Life Prediction of Riveted Joint

Finite element analysis of self-piercing riveting process

ANALYSIS OF THE PARAMETER EFFECT ON FATIGUE CRACK IN RIVETED COMPONENTS WITH FINITE ELEMENT METHOD

Assessing the riveting process and the quality of riveted joints in aerospace and other applications

A unified evaluation method for fatigue resistance of riveted joints based on structural stress approach