Abstract:Inertial sensors are key components of gravitational wave observations and Earth geodesy missions. An inertial sensor includes an isolated free-floating test mass (TM) surrounded by capacitive electrodes and a housing frame (EH) to perform the relative-position measurement and control the TM in six degrees of freedom. Owing to galactic cosmic rays and solar energetic particles, many additional accelerations are introduced through the Coulomb interaction between charged TMs and their surrounding conducting surfaces. Thus, the TM charge control is critical in space-based missions. A contact-free and ultraviolet light-based charge management system (CMS) was developed to reduce charge-induced noises acting on the TMs and minimize force disturbances that can perturb measurements or interrupt science tasks. However, the operating environment for space charge control is full of uncertainties and disturbances. Physical parameters in the discharging process are rarely measured and will vary owing to changes in solar activity, temperature, and so on. The unpredictability and variability of these parameters affects the CMS performance in long-term space missions and must be evaluated or eliminated. This paper presents a simplified physical model for the discharge process based on electron exchange between the TM and the opposing EH. Subsequently, a model reference adaptive control (MRAC) is proposed for the CMS with parametric uncertainties to maintain the TM charge below a certain level and improve its robustness. The simulation results show that the MRAC can automatically adjust control parameters to eliminate the effect of the variability of the aforementioned physical parameters, and the control precision can reach 0.1 mV under uncertainties, which is superior to that of a classic proportional-integral-derivative controller. This study demonstrated the effects of adaptive charge control and its potential for actual applications.

Study of On-board Micro Space Debris MOS Capacitor-type Detector

MOS capacitance probe for micro space debris detector

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

The Parasitic Capacitance's Influence on Noise in a MEMS Accelerometer Sensor

Experimental Study of Micrometeoroids Impacts on an X-Ray Telescope Model using Micro-pore Optics and CMOS Detector with Micron-sized Particles

Capacitive–Inductive Magnetic Plug Sensor With High Adaptability for Online Debris Monitoring

Research on the Characteristics of Micro Planar Capacitance Sensor for Multi Wear Particle Detection

An Analytical Model for Studying the Structural Effects and Optimization of A Capacitive Tactile Sensor Array

Structural Design of MEMS Acceleration Sensor Based on PZT Plate Capacitance Detection

Design, fabrication, and hypervelocity impact testing of screen-printed flexible micrometeoroid and orbital debris impact sensors for long-duration spacecraft health monitoring

Numerical analysis and experimental verification of the induced waveform characteristics for aeroengine gas path debris electrostatic sensor

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

Construction of a PZT Sensor Network for Low and Hypervelocity Impact Detection

Adaptive Charge Control for the Space Inertial Sensor

Capacitance Measurement for Evaluating the Initial Top-Electrode-Damage-Induced Degradation of Organic Devices

Discharge voltage behavior of electric double-layer capacitors during high-g impact and their application to autonomously sensing high-g accelerometers

Space Debris detection and tracking with the techniques of cosmic ray physics

High-Precision Inertial Sensor Charge Management Based on Ultraviolet Discharge: A Comprehensive Review

Match Function Method for Space Debris Detection Using Incoherent Scatter Radar

Capacitive Sensing-Based Charge Measurement for Space Inertial Sensors

Capacitive coupling study of the HERD SCD prototype: preliminary results