Abstract:Silicon -based ultra -thin flat heat pipes (UFHPs) that can be integrated with semiconductor devices provide an opportunity for electronic thermal management. To meet the requirements of various operation states, the impacts of gravity on the liquid plug characteristics and heat transfer performance of an UFHP are investigated by a visualization experiment conducted at different incline angles. Condensate flows back through microgrooves under the capillary pressure and gravity under a low heating power (capillary flow stage), and then excess condensate flows back along the edges of the UFHP under a higher heating power (gravitational flow stage). Over a certain heating power ( Q >= 14 W), liquid plug fluctuations caused by vapor entrainment are observed with periodic dry -out at the evaporator under large incline angles ( alpha >= 60 degrees ), corresponding to temperature fluctuations. Intense fluctuations of the liquid plug enhance sensible heat transfer, although the liquid plug occupies the condenser area and impedes the vapor flow. Meanwhile, evaporation at the evaporator benefits from corner -film evaporation until a large area of dry -out occurs. Due to the increased gravity and buoyancy, a larger incline angle is conducive to thermal performance enhancement, but this effect becomes restricted as the heating power rises. At a cooling -water temperature of 20 degrees C and an incline angle of 90 degrees , the lowest thermal resistances of the UFHP yield a value of 1.14 degrees C/W at 4 W in the steady stage and a value of 1.22 degrees C/W at 18 W in the fluctuation stage, respectively. The heat transfer limit of UFHP with overfilling reaches 24 W, compared with the theoretical heat transfer capacity of 8.9 W at an incline angle of 90 degrees . Additionally, a higher cooling -water temperature is beneficial for the thermal performance in the capillary flow stage, but not in the gravitational flow stage and fluctuation stage. This study provides guidance for the operational design of silicon -based UFHP for electronic thermal management.

Experimental Study of Flat Loop Heat Pipe With Bi-Transport Loops

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental investigation for the loop heat pipe with a bifacial flat evaporator

Experimental investigation on the start-up performance of a novel flat loop heat pipe with dual evaporators

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Experimental investigation on the start-up performance of a loop heat pipe with three flat disk evaporators combined

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Visualization study of a flat confined loop heat pipe for electronic devices cooling

Experimental study on a rectangular evaporator loop heat pipe with a phase-change material heat sink

Experimental investigation of a loop heat pipe with a flat evaporator and cupric oxide nanofluids as working fluid

Experimental Study on a Hydrogen Closed-Loop Pulsating Heat Pipe with Two Turns

Operating characteristics of a dual flat-evaporator loop heat pipe for single heat source cooling in any orientation

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Experimental Investigation Thermal Performance of Loop Heat Pipe Operating with Different Working Fluids

Investigation on the influence of the condenser length and its coupling effect with elevation on the performance of loop heat pipe

Experimental investigation on a flat loop heat pipe coupled with thermoelectric cooler

Experimental investigation on a pulsating heat pipe with low number of turns at liquid hydrogen temperature range

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

Liquid Plug Characteristics and Heat Transfer Performance of a Silicon-Based Ultra-Thin Flat Heat Pipe at Different Incline Angles