Abstract:Solid oxide fuel cell directly and efficiently converts chemical energy to electrical energy. However, the necessity for high operating temperatures can result in mechanical failure. Fuel cell is a multilayer system and its stress distribution is greatly affected by the interface morphology. In this work, cosine interfaces with different amplitudes are used to approximate the fluctuation of actual interface. The effects of interface morphology on stress state, energy release rate of crack and creep behavior have been investigated. The results show that if the interface is planar, the residual normal stress component is zero on the interface, while the nonplanarity of interface can cause the normal stress S-n and shear stress S-t on the interface. When the amplitude is relatively small, the max values of S-n and S-t on the interfaces vary linearly with increasing amplitudes in both anode and cathode. Above a certain value, nonlinearity of the interface becomes important. Max tensile S-n always occurs at the peak of convex interface, but the position of max compressive S-n varies. Max shear stress is prone to occur at 1/4 of the wavelength at small amplitude and moves towards 1/2 of the wavelength when the amplitude increases. Fracture mechanics analysis shows that the surface crack possibly penetrates into the anode function layer and then is constrained by the stiff electrolyte. On the other hand, the horizontal crack likely penetrates into the electrolyte layer when the interface is not planar. Creep analysis shows that 11 800 hours of continuous operation at high temperature cannot remove stress undulation introduced by nor-planar interface but can make max value of Sn and St decrease around 30%.

Finite element analysis of the fracture behaviour of multi-layered systems used in solid oxide fuel cell applications

Thermally Induced Failure of Multilayer Ceramic Structures

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

Fracture Simulation of Ni-YSZ Anode Microstructures of Solid Oxide Fuel Cells Using Phase Field Method

Multi-scale simulations of fracture behavior in CeO2

Numerical simulation of the residual stress of solid oxide fuel cells with a three-dimensional nonplanar cathode-electrolyte interface

Mechanics Behavior Induced by Chemical Expansion for Oxide Anode of Solid Oxide Fuel Cells

Effect of Interface Morphology on the Residual Stress Distribution in Solid Oxide Fuel Cell

Fracture Analysis on a Layered Multiferroic Smart Structure Containing Non-Periodic Interfacial Cracks under Magnetic/electric and Mechanical Loadings

Coarse-grained molecular dynamics modeling and parameter analysis for sintered interface structures in sandwiched tri-layers reversible solid oxide fuel cell

A Numerical Investigation of the Thermal Stresses of a Planar Solid Oxide Fuel Cell

Modeling of cooperative defect transport and thermal mismatch in a planar solid oxide fuel cell

A novel method to determine the particle-particle fracture of yttria stabilized zirconia

Effects of Electrode Composition and Thickness on the Mechanical Performance of a Solid Oxide Fuel Cell

Fracture simulation for zirconia toughened alumina microstructure

In-plane Fracture Analysis on the Magneto-Electro-elastic Interfacial Region in a Multiferroic Composite: Effects of Volume Fraction

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Porous LSCF/Dense 3YSZ Interface Fracture Toughness Measured by Single Cantilever Beam Wedge Test

Fracture Mechanics Analysis Model for Functionally Graded Materials with Arbitrarily Distributed Properties

Modeling of an Anode Supported Solid Oxide Fuel Cell Focusing on Thermal Stresses

Lattice Boltzmann simulation study of anode degradation in solid oxide fuel cells during the initial aging process