Experimental investigation of urea injection strategy for close-coupled SCR aftertreatment system to meet ultra-low NO<i><sub>x</sub></i> emission regulation
Shiyu Liu,Boyuan Wang,Zexian Guo,Buyu Wang,Zhaohuan Zhang,Xiao Ma,Chen-Teng Chang,Peng Wang,Xin He,Xingyu Sun,Shijin Shuai
DOI: https://doi.org/10.1016/j.applthermaleng.2021.117994
IF: 6.4
2022-01-01
Applied Thermal Engineering
Abstract:Worldwide automotive emission regulations for heavy-duty diesel engines are increasingly stringent, especially for nitrogen oxide (NOx) and particulate matter (PM). The development of high-efficiency aftertreatment technologies and the optimization of the urea injection strategies are key factors for the diesel engines to meet the future regulations. In this paper, the effects of temperature and space velocity on close coupled selective catalyst reduction (ccSCR) and SCR are investigated firstly. The highest NOx conversion efficiency of ccSCR and main SCR is observed at 350 degrees C, and an increase of space velocity leads to a more significant decrease on NOx conversion efficiency of ccSCR than that of SCR. Then three phases of urea injection state for both nozzles are determined according to the catalyst inlet temperature in the Federal Test Procedure (FTP) cycle. Urea injection strategy is optimized by urea injection ratio calibration and urea injection strategy updating based on the characteristic of three phases, as well as NH3 sensor feedback. Finally, the composite tailpipe NOx emission under FTP cycle is reduced below 0.027 g/kWM, satisfying California air resources board (CARB) ultra-low NOx emission regulation with a penalty of slight increase in CO2 emissions. However, adopting a high reactivity gasoline can improve the efficiency while maintaining the low level of NOx emissions.