Abstract:The triply periodic minimal surfaces (TPMS) structure is regarded as a highly promising artificial design, but the performance of composites constructed using this structure remains unexplored. Two porosity levels of Ti/Al interpenetrating phase composites (IPCs) were fabricated by infiltrating ZL102-Al melt into additive-manufactured TC4-Ti scaffolds with the TPMS porous in this study. The combination of the two-phase alloys exhibits structural integrity at the interfacial region, as evidenced by microscopic surfaces observed in uncompressed IPCs. Quasi-static compression tests were performed to demonstrate that the Young’s modulus, yield stress and maximum compressive stress of IPCs exhibit significant enhancement when compared to the individual TPMS scaffolds, due to the supporting and strengthening effect of the filling phase. In the compression process of IPCs, defects emerge initially at the interface between the ZL102 phase and TC4 phase, triggering the fracture and slip of the ZL102 phase, eventually propagating to involve fracture in the TC4 phase. The deformation behaviours obtained from numerical simulation were combined to support these experimental phenomena. The results show that the corresponding stress concentration region is the central region of the spiral surface, the maximum stress concentration region of the ZL102 phase is the same as that of the TC4 phase, and the ZL102 phase effectively shares part of the loading. The Ti/Al IPCs achieve equivalent load-bearing capacity through a simplified interpenetration process and the utilisation of lighter materials.

Metal-matrix interpenetrating phase composite and its in situ fracture observation

Novel MMC microstructure with tailored distribution of the reinforcing phase

MMCs with Controlled Non-Uniform Distribution of Submicrometre Al2O3particles in 6061 Aluminium Alloy Matrix

Metal-matrix Interpenetrating Phasecomposites Produced by Squeeze Casting

Study on Microscopic Ductile Fracture of In-Situ TiB2/2024 Al Matrix Composite

Investigation of Multi-Phase Intermetallic Matrix Composites (IMC) Based on Al–Mo–Zr–Co System

Experimental Investigation on Machinability of in Situ Formed TiB2 Particles Reinforced Al MMCs

In-Situ Observation of Fracture Behavior of Ti-Aluminide Multi-Layered Composites Produced by a Hybrid Sintering Process

Mechanisms and FEM Simulation of Chip Formation in Orthogonal Cutting In-Situ TiB2/7050Al MMC

Compressive Properties and Fracture Behaviours of Ti/Al Interpenetrating Phase Composites with Additive-Manufactured Triply Periodic Minimal Surface Porous Structures

Study on Microstructure and Tensile Properties of in Situ Fiber Reinforced Aluminum Matrix Composites

Study On Chip Formation And Simulation Of Cutting In-Situ Tib2 Particle Reinforced 7050al Metal Matrix Composites

Approach to In-Situ Producing Reinforcing Phase Within an Active-Transient Liquid Phase Bond Seam for Aluminum Matrix Composite

Interface-dominated Mechanical Behavior in Advanced Metal Matrix Composites

A Novel Ti/Al Interpenetrating Phase Composite with Enhanced Mechanical Properties

In Situ Formed Core–shell Structured Particle Reinforced Aluminum Matrix Composites

Design of bimetallic interpenetrating biomimetic structures and additive-casting synergetic manufacturing

The Making of Metal-Matrix Interpenetrating Phase Composites by Squeeze Casting

Meso-fracture of Metal Matrix Composites Reinforced by Particles of Large Volume Fraction

Study on the Making of Metal-Matrix Interpenetrating Phase Composites

Structure, Thermal and Mechanical Properties of in Situ Al-Based Metal Matrix Composite Reinforced with Al2o3 and Tic Submicron Particles