Abstract:Currently, activated coke is widely used in the removal of multiple pollutants from industrial flue gas. In this paper, a series of novel FexLayOz/AC catalysts was prepared by the incipient wetness impregnation for NH3-SCR denitrification reaction. The introduction of Fe-La bimetal oxides significantly improved the denitrification performance of activated coke at mid-high temperature, and 4% Fe0.3La0.7O1.5/AC exhibited a superior NOx conversion efficiency of 90.1% at 400 °C. The catalysts were further characterized by BET, SEM, XRD, Raman, EPR, XPS, FTIR, NH3-TPD, H2-TPR, et al., whose results showed that the perovskite-type oxide of LaFeO3 and oxygen vacancies were produced on the catalysts’ surfaces during roasting. Fe-La doping enhanced the amount of acid sites (mainly Lewis and other stronger acid sites) and the content of multifarious oxygen species, which were beneficial for NOx removal at mid-high temperature. Moreover, it was investigated that the effect of released CO from activated coke at mid-high temperature on the NOx removal through the lifetime test, in which it was found that a large amount of CO produced by pyrolysis of activated coke could promote the NOx removal, and long-term escaping of CO on the activated coke carrier did not have a significant negative impact on catalytic performance. The results of the TG-IR test showed that volatile matter is released from the activated coke while TG results showed that the weight loss rate of 4% Fe0.3La0.7O1.5/AC only was 0.0015~0.007%/min at 300–400 °C. Hence, 4% Fe0.3La0.7O1.5/AC had excellent thermal stability and denitrification performance to be continuously used at mid-high temperature. Finally, the mechanisms were proposed on the basis of experiments and characterization results.

Uses of Activated Carbon Fiber-supported Catalysts in the Flue Gas Denitrification

Activated Carbon-supported Catalysts for Denitrification of Flue Gas at Low Temperature

Investigation of modified carbon-based catalyst on low-temperature selective reduction of flue gas denitration performance

Progress of Study on Desulferization and Denitrification with Activated Carbon Fibers

Investigation of water resistant performance of activated carbon supported tungstophosphoric acid in the process of flue gas denitration

Ni Supported on Activated Carbon As Catalyst for Flue Gas Desulfurization

Research progress on the regeneration of SCR catalysts for flue gas denitrification

Performance on desulfurization and denitrification of one-step produced activated carbon for purification of sintering flue gas

Study on the Denitrification Performance of FexLayOz/activated Coke for NH3-SCR and the Effect of CO Escaped from Activated Coke at Mid-High Temperature on Catalytic Activity.

RESEARCH STATUS OF LOW-TEMPERATURE DENITRIFYING CATALYSTS

SELECTIVE REDUCTION DENITRIFICATION OF FLUE GAS BY USING CATALYST Ag/Al2O3 AND REDUCING AGENT C3H6

Nitrogen Doping of Activated Carbon Loading Fe2O3 and Activity in Carbon-Nitric Oxide Reaction

Performance of SCR denitration of impregnated catalysts using activated carbon as support

RESEARCH ACHIEVEMENTS OF CATALYSTS FOR SCR DENITRIFICATION BY NH3 AND HYDROCARBON

Coupling mechanism of activated carbon mixed with dust for flue gas desulfurization and denitrification

Revealing the Key Role of Acidic Oxygen-Containing Groups on Activated Carbon for Low-Temperature NH3-SCR Denitration

Recent advance for NOx removal with carbonaceous material for low-temperature NH3-SCR reaction

Selection of Carbon Materials and Modification Methods in Low-Temperature Sintering Flue Gas Denitrification

Research on deeply modified Fenton sludge for the selective catalytic reduction of NO x : Promotion mechanism of acidification reorganization

Progress of selective catalytic reduction denitrification catalysts at wide temperature in carbon neutralization

Room Temperature Nox Removal Over Carbon Nanofibers Fabricated By Electrospinning