Abstract:The usage of too many sizeable capacitors significantly increases the volume and cost of the modular multilevel converter (MMC), and limits its spread in medium- and high-voltage applications. By adding a buck-type active power filter (APF) circuit into a particular MMC topology [of which each phase multiplexes one submodule (SM)], a modified MMC (APF-M3C) topology, which inherently has the ability to suppress capacitor voltage fluctuations and decrease the power losses compared with conventional MMC topology, is proposed in this article. Both the SM capacitor voltage ripples, which can be reduced up to 50% of original value and are related to the SM capacitance, and the arm currents, which are related to SM power losses, are calculated in detail. Its topology, and operating principle is presented in detail, and a novel modulation method for the APF-M3C topology are proposed. In addition, an improved control method for the voltage balancing is also recommended to further reduce system cost and power losses. Finally, the APF-M3C topology and traditional MMC simulation and experimental platforms were built. Simulations and experimental results verify the feasibility and effectiveness of the APF-M3C topology and control strategy by comparing with the conventional MMC.

Frequency limited critical conduction mode APFC based on UC3852

Modeling and Controller Design of Active Power Factor Correction Based on L6562A

Start-stop Control Strategy for UPFC with Fault Current Limiting

Modular Multilevel Converter for Unified Power Flow Controller Application

Design and Research of a Novel Unified Power Flow Controller with Fault Current Limiter

An Improved Topology of Unified Power Flow Controller Based on MMC with Fault Current Limiting

Parameter design and optimization of unified power flow controller with fault current limiting

Dc Capacitor Parameter Design Of Unified Power Flow Controller With Fault Current Limiting

High efficiency PFC with Enabling Window Control and active input bridge

An Optimal Peak Current Mode Control Scheme for Critical Conduction Mode (crm) Buck Pfc Converter

Optimal Switching Frequency Variation Range Control for Critical Conduction Mode Boost Power Factor Correction Converter

Parameters Design and Example of Unified Power Flow Controller with Fault Current Limiting

A Multiplexing Modulation Strategy Based On Single-Phase Ac/Dc Converter With Optimized E-Capless Function

UPFC with fault current limiting and capacitor voltage limiting

Active Power Decoupling for a Modified Modular Multilevel Converter to Decrease Submodule Capacitor Voltage Ripples and Power Losses

A High-Efficiency 12/1-V Dual-Path Series-Capacitor Converter with Low $v\cdot A$ Metric and Full Duty Range

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

A modular multilevel converter with active power filter (APF-MMC) under low-frequency operation

Advanced Modulation Scheme with Loss Balancing Effect under Low-Modulation Operation for FC-T2C Converter

An Improved Modulation Strategy for Single-Phase Three-Level Neutral-Point-Clamped Converter in Critical Conduction Mode

Design and Loss Analysis of the High Frequency Pfc Converter