Abstract:Background: Xenon-enhanced dual-energy (DE) computed tomography (CT) and hyperpolarized noble-gas magnetic resonance imaging (MRI) provide maps of lung ventilation that can be used to detect chronic obstructive pulmonary disease (COPD) early in its development and predict respiratory exacerbations. However, xenon-enhanced DE-CT requires high radiation doses and hyper-polarized noble-gas MRI is expensive and only available at a handful of institutions globally. Purpose: To present xenon-enhanced dual-energy tomosynthesis (XeDET) for low-dose, low-cost functional imaging of respiratory disease in an experimental phantom study. Methods: We propose using digital tomosynthesis to produce Xe-enhanced low-energy (LE) and high-energy (HE) coronal images. DE subtraction of the LE and HE images is used to suppress soft tissues. We used an imaging phantom to investigate image quality in terms of the area under the reciever operating characteristic curve (AUC) for the Non-PreWhitening model observer with an Eye filter and internal noise (NPWEi). The phantom simulated anatomic clutter due to lung parenchyma and attenuation due to soft tissue and lung tissue. Aluminum slats were used to simulate rib structures. A stepwedge consisting of an acrylic casing with sealed cylindrical air-filled cavities was used to simulate ventilation defects with step thicknesses of 0.5, 1, and 2 cm and cylindrical radii of 0.5, 0.75, and 1 cm. The phantom was ventilated with Xe and projection data were acquired using a flat-panel detector, a tube-voltage combination of 60/140 kV with 1.2 mm of copper filtration on the HE spectrum and an angular range of ± 15 ∘ $\pm 15^{\circ}$ in 1° increments. The AUC of a NPWEi observer that has access only to a single coronal slice was calculated from measurements of the three-dimensional noise power spectrum and signal template. The AUC was calculated as a function of ventilation defect thickness and radius for total patient entrance air kermas ranging from 1.42 to 2.84 mGy with and without rib-simulating Al slats. For the AUC analysis, the observer internal noise level was obtained from an ad hoc calibration to a high-dose data set. Results: XeDET was able to suppress parenchyma-simulating clutter in coronal images enabling visualization of the simulated ventilation defects, but the limited angle acquisition resulted in residual clutter due to out-of-plane bone-mimmicking structures. The signal power of the defects increased linearly with defect radius and showed a ten-fold to fifteen-fold increase in signal power when the defect thickness increased from 0.5 to 2 cm. These trends agreed with theoretical predictions. Along the depth dimension, the power of the defects decreased exponentially with distance from the center of the defects with full-width half maxima that varied from 1.85 to 2.85 cm depending on the defect thickness and radius. The AUCs of the 1-cm-radius defect that was 2 cm in thickness ranged from good (0.8-0.9) to excellent (0.9-1.0) over the range of air kermas considered. Conclusions: Xenon-enhanced DE tomosynthesis has the potential to enable functional imaging of respiratory disease and should be further investigated as a low-cost alternative to MRI-based approaches and a low-dose alternative to CT-based approaches.

An Initial Experience on Xenon-Enhanced Dual-Energy CT Ventilation Imaging of Lung Cancer

Probing Changes in Lung Physiology in COPD Using CT, Perfusion MRI, and Hyperpolarized Xenon-129 MRI

Clinical eraluation of dual-source CT enterography using dual-energy rirtual non-enhanced technique

A pilot study of function-based radiation therapy planning for lung cancer using hyperpolarized xenon-129 ventilation MRI

Xenon-Enhanced Dual-Energy CT Lung Ventilation Imaging: Techniques and Clinical Applications

Comparison of test bolus and bolus tracking techniques for dual-energy CT lung perfusion scan

Virtual non-contrast of liver from dual energy CT: a clinical application

Dynamic Contrast-Enhanced Computed Tomography Functional Imaging for the Evaluation of Tumor Angiogenesis in Patients with Lung Carcinoma

Xenon-enhanced dual-energy tomosynthesis for functional imaging of respiratory disease-Concept and phantom study

Dual Energy CT Lung Perfusion Imaging Using Dual Source CT :Optimization of Contrast Medium Use and Radiation Dose

Generation of ventilation/perfusion ratio map in surgical patients by dual-energy CT after xenon inhalation and intravenous contrast media

Dual Energy CT Ventilation Imaging after Aerosol Inhalation of Iodinated Contrast Medium in Rabbits.

Dual-energy CT Imaging of Thoracic Malignancies

Spectral CT Imaging As a New Quantitative Tool? Assessment of Perfusion Defects of Pulmonary Parenchyma in Patients with Lung Cancer.

Time-series hyperpolarized xenon-129 MRI of lobar lung ventilation of COPD in comparison to V/Q-SPECT/CT and CT

Lobar Ventilation in Patients with COPD Assessed with the Full-Scale Airway Network Flow Model and Xenon-enhanced Dual-Energy CT

Evaluaion of Application with Dual-Energy CT:Virtual Non-Contrast Images of the Pancreatic Carcinoma

Influent factors in thorax image quality on sensation 64-slice spiral CT:a phantom study

Xenon-Enhanced Dynamic Dual-Energy CT Is Able to Quantify Sinus Ventilation Using Laminar and Pulsating Air-/Gas Flow Before and After Surgery: A Pilot Study in a Cadaver Model

Dual-Energy CT for the Assessment of Contrast Material Distribution in the Pulmonary Parenchyma

Clinical Application of Contrast-Enhanced Ultrasonography in Central Lung Cancer with Obstructive Atelectasis