Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

NUMERICAL EVALUATION FOR THE THERMAL STABILITY PROFILE IN HIGH TEMPERATURE SUPERCONDUCTIVE COIL WORKING WITH HIGH CURRENT SHOCK

Simulation of the Safety Against Ac and Dc Current Shock Pulses in a High Temperature Superconductive Coil

Numerical simulation of the thermal behavior of a YBCO coil at low temperatures

A Method for Measuring AC Critical Current of HTS Coil Based on Thermal Stability

Thermal stability analysis of high temperature superconducting magnet coils under overcurrent pulses

The stability of the high temperature superconducting DC coils with defects

Analysis on charge-discharge characteristics of the high temperature superconducting coil

Thermal Stability and Mechanical Behavior in No-Insulation High-Temperature Superconducting Pancake Coils

Numerical Analysis of Thermal Stability and Mechanical Response in a No-Insulation High-Temperature Superconducting Layer-Wound Coil

Test and Analysis of Electromagnetic and Mechanical Properties of HTS Coil During Quench State

Quench Characteristics Comparison Between Solid Nitrogen and Conduction Cooled REBCO Coil under Thermal Disturbance and over Current Pulse

Two Quenched Models for High-Temperature Superconducting Insulated Coils

Performance of an HTS Generator Field Coil under System Fault Conditions

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Analysis of Overcurrent Performance of YBCO Tape Considering Different Heat Exchange Conductions

Thermal Stability Analysis of YBCO Tapes under DC Overcurrent

Experimental Study of Thermal Stability of HTS Cable under DC Overcurrent.

Electromagnetic and AC Loss Characteristics Analysis of HTS Coils

Temperature field numerical analysis on the cold dielectric high temperature superconducting cable under varying operating current

Study of Method of Measuring and Determining HTS Coil's Critical Current with $V$– $I$ Properties Between Different Parts of the Coil

Fast evaluation of the critical current of high-temperature superconducting coils based on the integral method