Abstract:Large volume cubic press is one of the most popular high pressure devices which can produce pressures up to about 7 GPa. It is well known experimentally that the enhancing of the maximum pressure generated in the large volume cubic press has attracted wide attention among scientists and engineers because the higher pressure is capable of synthesizing some materials with interesting properties. In the large volume cubic press, pyrophyllite is typically used as a pressure-transmitting medium. A specimen immersed in such a solid experiences a generalized stress state. The pressure distribution in pyrophyllite is an important parameter for characterizing the sample environment and designing the experiments at high pressure. There is a need for the quantitative measurement of pressure gradients in the pyrophyllite pressure medium, so that the accurate experimental data under high pressure can be obtained. In the large volume cubic apparatus (68 MN), we put a circuit into the high pressure cubic cell, so that the pressures at various positions can be measured by using the phase transitions in Bi, Tl and Ba. In the present work, the relationship between the total press load and the press load allocated to the anvil face, and the relationship between the total press load and the press load allocated to gaskets are established at room temperature. The results show that with the increase of the total press load, the load allocated to the gaskets is increased sharply, while the curve of load allocated to the anvil face versus total press load reaches a plateau, which results in the cell pressure reaching upper limit when the cell pressure reaches up to about 5 GPa. According to the experimental results, the stress state of the cubic cell under high pressure is analyzed and the reason why the pressure generated in the large volume cubic chamber is difficult to exceed 7 GPa is explained. Based on the geometrical structure of the cubic cell, the scheme to increase the upper pressure limit for cubic cell by using the material with high bulk modulus as the pressure transmitting medium and the material with low bulk modulus as the gasket, is proposed. Additionally, the method of calculating the pressure values at different positions along the axis of symmetry in the cubic cell is given through the quantitative calibration of the pressure gradient in the axial direction of the cubic cell. This method can provide more accurate pressure data for high pressure experiments.

Large volume high pressure research using the wiggler port at NSLS

High-Pressure Energy-Dispersive X-Ray-Diffraction Technique With Synchrotron-Radiation

Force Analysis and Pressure Quantitative Measurement for the High Pressure Cubic Cell

High-pressure synchrotron infrared spectroscopy at the national synchrotron light source

A System for Doing Low Temperature-High Pressure Single Crystal X-ray Diffraction with a Synchrotron Source

Synchrotron X-ray powder diffraction under high pressures up to 33 MPa for mechanoresponsive materials

A Focusing System for X-ray Diffraction Studies of Materials under High Pressure in the Diamond Cell

APPLICATION OF SYNCHROTRON RADIATION TO HIGH PRESSURE X-RAY DIFFRACTION

Energy dispersive x-ray diffraction of micro-crystals at ultrahigh pressures

A high-pressure single-crystal-diffraction experimental system at 4W2 beamline of BSRF

Femtosecond diffraction and dynamic high pressure science

High pressure gas vessels for neutron scattering experiments

Coherent diffraction imaging of nanoscale strain evolution in a single crystal under high pressure

Submillisecond in situ X‐ray diffraction measurement system with changing temperature and pressure using diamond anvil cells at BL10XU/SPring‐8

Synchrotron X-Ray-Diffraction from A Microscopic Single-Crystal under Pressure

High-pressure Neutron Diffraction Studies at LANSCE

HIGH-PRESSURE SYNCHROTRON X-RAY DIFFRACTION OF CS IV AND CS V

Two-dimensional Energy Dispersive X-Ray Diffraction at High Pressures and Temperatures

Large-volume diamond cells for neutron diffraction above 90 GPa

Tracking structural phase transitions via single crystal x-ray diffraction at extreme conditions: advantages of extremely brilliant source

High-pressure Studies with X-Rays Using Diamond Anvil Cells