Abstract:To effectively replace the isotope radiation source in litho-density logging, this study presents a method for measuring the formation density and photoelectric absorption index (Pe) using a switchable X-ray tube. First, the gamma-ray litho-density logging (GLD) method for measuring formation density and Pe using chemical sources is introduced. Then, a benchmark verification based on the X-ray litho-density logging tool prototype and data published by Simon (In: Paper presented at the SPWLA 59th annual logging symposium, London, UK, 2018) was carried out using Monte Carlo numerical simulations. Second, the impacts of the photoelectric effect and detector statistical error on the GLD method were analyzed. Finally, based on a theoretical analysis, the formation density and Pe measurement algorithm (double energy window (DEW) method) was improved, which was found to be suitable for X-ray litho-density logging. Moreover, the results obtained using this algorithm were compared with those obtained using the GLD method. The results indicate that owing to the impact of photoelectric effect and detector statistical error on the density energy window, the accuracy of formation density and Pe measurement using the GLD method is relatively low, with the uncertainty in formation density and Pe measurement reaching 2.620 ± 0.047 g/cm3 and 4.090 ± 0.580 b/e, respectively. In comparison, the DEW method can improve the accuracy of density and Pe measurement to 0.006 g/cm3 and 0.065 b/e, respectively, as the photoelectric effect in the density window is corrected using the counts in the lithology window of the energy spectrum. This study aims to provide a new theoretical foundation for processing X-ray litho-density logs in the future.

Low Count Bias in Gamma Ray Thickness Detection and Its Correction

New correction method for dynamic error in on-line gamma ray thickness detection.

Rigorous analysis of the spatial dispersion effect in multilayer thin-film coatings.

Correction of Dynamic Error in On-Line Thickness Measurement by Gamma-Ray Transmission

A Count Correction Method for Multistage Dead Time in Gamma-Ray Spectrometry

Study on Correction Method of Counting Loss below the Threshold for Low Energy Radionuclides Based on Monte Carlo Simulation

Scattering Correction of X-ray Thickness Gauge

Origin Ensemble Algorithm Based Doppler Broadening Effect Correction for CZT Compton Camera in Prompt Gamma Imaging: A Monte Carlo Study

Study on the Weights of Influencing Factors Contribution to Background Count Rate in Liquid Scintillation Measurement

Employing A Cerenkov Detector for the Thickness Measurement of X-Rays in A Scattering Background

Numerical simulation and method study of X-ray litho-density logging

Sources of Variability in Alpha Emissivity Measurements at LA and ULA Levels, a Multicenter Study

PRECISION: A Physics-Constrained and Noise-Controlled Diffusion Model for Photon Counting Computed Tomography

Corrections to "Multilayer Perception Model Versus Charge Comparison Method for Neutron/Gamma Discrimination in Plastic Scintillator According to Sampling Frequency and Energy Radiation"

Large-scale power loss in ground-based CMB mapmaking

A Method of Detector Correction for Cosmic Ray Muon Radiography

Testing for shielding of special nuclear weapon materials

Biases in galaxy spectral analysis from strong lensing differential magnification effect and correction methods

Investigation of gamma-ray sensitivity of neutron detectors based on thin converter films

Multilayer Thin Film Thickness Measurement Using Sensitivity Separation Method

Research on calibration model of X ray thickness gauge