Effect of Oxidation Catalyst on Formaldehyde Emission from Methanol Compression Ignition

Chunde YAO,Hongmei PENG,Yiting LIU,Shuai LI
DOI: https://doi.org/10.3321/j.issn:0253-2468.2008.06.002
2008-01-01
Abstract:A diesel engine was operated in a diesel/methanol compound combustion mode(DMCC)in bench tests.Gas chromatography analysis was used to detect the formaldehyde emission from the engine while it was operating at 1800 r·min-1.The influence of load,methanol ratio,oxidation catalytic converter and exhaust temperature on formaldehyde emission was investigated.The experimental results showed that the formaldehyde emission increased with the increasing of methanol proportion at low load,and its concentration reached 180×10-6 when the methanol proportion was 46% in thermo-value in the fuel.The formaldehyde was cut down about 25%-44% when an oxidation catalyst was used.The formaldehyde emission did not changed much with the proportion of methanol in the fuel when the engine ran at the load higher than that medium ones,nevertheless,the formaldehyde emission was slightly higher at heavy load than that of medium one.However,under certain conditions,the formaldehyde emission was increased while using the oxidation catalyst.The transfer efficiency of the oxidation catalytic converter is dependent on the temperature of the exhaust.The formaldehyde emission from DMCC engine with an oxidation catalytic converter decreased at exhaust temperatures below 300℃,however,it increased between 300℃ and 410℃.When the temperature was higher than 425℃,the formaldehyde was greatly reduced again.
What problem does this paper attempt to address?