Abstract:The cathode microporous layer (MPL), as one of the key components of the proton exchange membrane fuel cell (PEM-FC), requires specialized carbon materials to ensure the two-phase flow and interfacial effects. In this respect, we designed a novel MPL based on highly hydrophobic carbon nanowalls (CNW). Employing plasma-assisted chemical vapor deposition techniques directly on carbon paper, we produced high-quality microporous layers at a competitive yield-to-cost ratio with distinctive MPL properties: high porosity, good stability, considerable durability, high hydrophobicity, and substantial conductivity. The specific morphological and structural properties were determined by scanning electron microscopy, X-ray photoelectron spectroscopy, and Raman spectroscopy. Thermo-gravimetric analysis was employed to study the nanostructures' thermal stability and contact angle measurements were performed on the CNW substrate to study the hydrophobic character. Platinum ink, serving as a fuel cell catalyst, was sprayed directly onto the MPLs and incorporated in the FC assembly by hot-pressing against a polymeric membrane to form the membrane-electrode assembly and gas diffusion layers. Single-fuel-cell testing, at moderate temperature and humidity, revealed improved power performance comparable to industrial quality membrane assemblies (500 mW cm-2 mg-1 of cathodic Pt load at 80 °C and 80% RH), with elevated working potential (0.99 V) and impeccable fuel crossover for a low-cost system.

Improving the Performance of A Pemfc with Ketjenblack Ec-600jd Carbon Black As the Material of the Microporous Layer

The Performance Improvement of Membrane and Electrode Assembly in Open-Cathode Proton Exchange Membrane Fuel Cell

Titanate-Grafted Carbon Black-Facilitated MPLs for Advanced Proton Exchange Membrane Fuel Cells

Performance improvement of ultra-low Pt proton exchange membrane fuel cell by catalyst layer structure optimization

Performance Improvement in Direct Methanol Fuel Cell Cathode Using High Mesoporous Area Catalyst Support

Performance Enhancement of Air-Breathing Proton Exchange Membrane Fuel Cell Through Utilization of an Effective Self-Humidifying Platinum–carbon Catalyst

Enhance the Durability of the Oxygen Reduction Reaction Catalyst Through the Synergy of Improved Graphitization and Nitrogen Doping of Carbon Carrier

Enhanced operational performance of PEM fuel cells with Porous-Carbon catalyst support: A multiscale modeling approach

Boosting the Performance of Low-Platinum Fuel Cells Via a Hierarchical and Interconnected Porous Carbon Support.

Effects of the carbon black properties in gas diffusion layer on the performance of proton exchange membrane fuel cells

Rational design of carbon network structure in microporous layer toward enhanced mass transport of proton exchange membrane fuel cell

Performance of Proton Exchange Membrane Fuel Cell Electrodes Prepared by Direct Deposition of Ultrathin Platinum on the Membrane Surface

Silane-functionalized Carbon with Super-Hydrophobicity Advancing Microporous Layer for Proton Exchange Membrane Fuel Cells

Enhanced MEA Performance for PEMFCs under Low Relative Humidity and Low Oxygen Content Conditions Via Catalyst Functionalization

Coaly Graphite as an Eco-Friendly Material in the Microporous Layer of Proton Exchange Membrane Fuel Cells

Improving of Micro Porous Layer based on Advanced Carbon Materials for High Temperature Proton Exchange Membrane Fuel Cell Electrodes

High-Performance Proton Exchange Membrane Fuel Cells Enabled by Highly Hydrophobic Hierarchical Microporous Carbon Layers Grafted with Silane

Mesoporous carbon aerogel with tunable porosity as the catalyst support for enhanced proton-exchange membrane fuel cell performance

Carbon-Nanowall Microporous Layers for Proton Exchange Membrane Fuel Cell

Gradient Hydrophobic Microporous Layer for High-Performance Proton-Exchange Membrane Fuel Cells

The influences of catalyst combination on the high temperature proton exchange membrane fuel cell