Abstract:The classical switching-table-based direct torque control (ST-DTC) suffers from issues such as large torque ripples, significant current harmonics, and variable switching frequency. In this paper, a novel ST-DTC is proposed to improve the current and torque steady-state performance for dual three-phase permanent magnet synchronous motor (DTP-PMSM). Firstly, proportional resonance (PR) controllers are used in the x-y subspace, and the x-y reference voltage generated by PR controllers is modulated by three fixed vectors based on the analysis of flux and torque slopes of voltage vectors with different amplitudes. This reduces current harmonics and computational burden of modulating the x-y reference voltage. Secondly, duty-ratio modulation is employed to reduce the torque ripple. However, under the traditional torque regulator, the duty-ratio modulation exists a torque range where it cannot achieve the instantaneous zero error of torque at the end of the control period. Therefore, the feedback value of the torque regulator is modified to further suppress torque ripple. Furthermore, to prevent generating incorrect switch sequences caused by the short dwell time of vectors and maintain the thermal balance of the inverter, an optimization of the switching sequence is performed. Finally, experimental results are presented to validate the effectiveness of the proposed method.

A Novel Sliding Mode Variable Structure Direct Torque Control for Permanent Magnet Synchronous Motor Drive System

Linear Sliding Mode Variable Structure Direct Torque Control for PMSM System

Linear Sliding-mode Variable Structure Research of Direct Torque Control for IPMSM

Direct Torque Control Based on Simple Duty Ratio and Fixed Switching Frequency for PMSM

The PMSM DTC Based on Variable Structure Sliding Mode

The Simulation Study of New Direct Torque Control Technology for Permanent Magnet Synchronous Motor

A New Variable Structure Controller for Direct Torque Controlled Interior Permanent Magnet Synchronous Motor Drive

Research on the Method of Direct Torque Control of Permanent Magnet Synchronous Motor Switching Frequency Constant

Investigation and Simulation Analysis of Direct Torque Control in Permanent Magnet Synchronous Motor

A Novel Switching-Table-Based Direct Torque Control with Improved Current and Torque Steady-State Performance for Dual Three-Phase PMSM

Novel Direct Torque Control Strategy in Permanent Magnet Synchronous Motor

Model Predictive Direct Torque Control for PMSM with Duty Cycle Optimization

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

A Novel Direct Torque Control Method with the Compensation of Rotating EMF to Reduce Torque Ripple for Permanent Magnet Synchronous Motor Drives

A Novel Sliding Hysteresis Band Based Direct Torque Control Scheme for PMSM Motors to Achieve Improved Current THD With Reduction in Torque and Flux Ripples Eliminating the Low-Speed Problems

Fuzzy-Logic-Based Direct Torque Control Research on Permanent Magnet Synchronous Motor

A Novel Direct Torque Control Permanent Magnet Synchronous Motor Drive Used in Electrical Vehicle

Direct-torque control of the brushless double-fed machines based on sliding-mode variable structure control strategy

Analysis of direct torque control in permanent magnet synchronous motor drives

New direct torque control method considering voltage vector duty ratio used in PMSM drive

The Technology Study of Direct Torque Control Method for Permanent Magnet Synchronous Motor