Abstract:This experimental study was conducted with a heavy-duty diesel engine fuelled with dimethyl ether (DME). The combustion and emission characteristics of DME engine were investigated. The results show that the peaks of in-cylinder pressure, heat release rate (HRR), pressure rise rate (PRR), and mean gas temperature of the DME engine are lower than those of diesel engines. For DME engines, with increase in the engine load, the diagram of HRR varies from two peaks to a single peak. With increasing engine speed under the same mean effective pressure, the ignition timing is delayed, and the heat release centroid gradually moves away from the top death centre (TDC). The DME engine with an injector of six holes and a Plunger of larger diameter exhibits a good performance owing to a faster diffusion combustion. With increase in fuel delivery advance angle at rated power, the ignition timing advances, and the centroid of the HRR is near the TDC. However, the peak of the HRR is at the same level. The results also show that higher torque and power can be achieved with DME than with diesel fuel operation at full load. At full load, the fuel consumption at low engine speeds with DME is lower than with diesel fuel, and nitrogen oxide emissions of the DME engine decrease markedly. Hydrocarbon emissions reduce while carbon monoxide emission slightly increases. The combustion of the DME engine is free of smoke throughout all the operating points. As DME is an oxygenated fuel, its combustion produces less carbon dioxide than that from diesel combustion. European stationary cycle emission test results show that the emissions from the DME engine are below the limits of the Euro 3 regulations.

Experimental study on exhaust emissions from a multi-cylinder DME engine operating with EGR and oxidation catalyst

Experiments on Emission Control of a Vehicle Direct-injection DME Engine

Experimental Study of EGR on Performance and Emissions of a Turbocharged DME Engine

Study on Combustion and Emission Characteristics of a Vehicle Engine Fuelled with Dimethyl Ether

Investigation on Emission Characteristics of A Compression Ignition Engine with Oxygenated Fuels and Exhaust Gas Recirculation

Experimental study on combustion and performance of a turbocharged DME engine

Performance and Emission Characteristics of Dme Engine with High Ratio of Egr

Study on Low Nitrogen Oxide and Low Smoke Emissions in a Heavy-Duty Engine Fuelled with Dimethyl Ether

Combustion and Emission Control in DME Engine Using Internal-External Exhaust Gas Recirculation

Investigation of dimethyl ether engine NOx reduction to china IV and V regulation by exhaust gas recirculation

Regulated And Nonregulated Emissions From A Dimethyl Ether Powered Compression Ignition Engine

FL4-1: Experimental Study on Combustion and Performance of a Turbocharged DME Engine(FL: Fuels and Lubricants,General Session Papers)

Effect Of Dimethoxy-Methane And Exhaust Gas Recirculation On Combustion And Emission Characteristics Of A Direct Injection Diesel Engine

EGR Strategy for DME Engine‐out NOx to Meet Euro V

A Study on the Performance and Emission Characteristics of CA498A Dimethyl Ether Engine

Experimental study of effects of exhaust gas recirculation and combustion mode on combustion, emission, and performance of DME‐methanol ‐fueled turbocharged c ommon‐rail engine

An Investigation on Combustion and Exhaust Emissions of Direct Injection Diesel Engine Fuelled with Dimethyl Ether

Diesel Emission Improvements by the Use of Oxygenated DME/diesel Blend Fuels

Experimental Investigation on Performance of Vehicle Dimethyl Ether Engine with Two Different Kinds of Lubricant Additives

Combustion and performance of heavy-duty diesel engines fuelled with dimethyl ether

Study of Combustion and Emission Characteristics of Turbocharged Diesel Engine Fuelled with Dimethylether