Abstract:Recently, the construction of stable superhydrophobicity on metallic wetting surfaces has gained increasing attention due to its potential wide applications. In this paper, we propose an economic fabricating method, which not only is suitable for metallic planar surfaces, but also could be applied onto cylindrical inner surfaces. It mainly involves two steps: etching micro-concaves by a movable mask electrochemical micromachining (EMM) technique and fabricating nanopillars of ZnO by a hydrothermal method. Then the influences of surface morphology on the static and dynamic behaviors of water droplets are investigated. The energy loss during impact on the surfaces is quantified in terms of the restitution coefficient for droplets bouncing off the surfaces. For hierarchical structures with excellent superhydrophobicity (contact angle :,approximate to 180 degrees and sliding angle <= 1 degrees), the droplet bounces off the surface several times, superior to the droplet's response on single nanopillars (contact angle :,approximate to 165.8 degrees and sliding angle :,approximate to 6.29 degrees) where droplet bounces off only for limited a number of times, and even far better than the dynamics of a liquid droplet impinging on microstructures (contact angle :,approximate to 132.1 degrees and sliding angle >90 degrees) where droplet does not rebound and remains pinned. The highest elasticity is obtained on the hierarchical surface, where the restitution coefficient can be as large as 0.94. The fabricating method is then applied onto the cylindrical inner surface and the wetting behavior is confirmed to be consistent with the planar surface. This method, which can be generalized to any kind of solid electroconductive metal or other surfaces with different shapes, could find wide practical applications in self-cleaning surfaces, chemical industry, microfluidic devices, mechanical engineering and aviation. (C) 2014 Elsevier B.V. All rights reserved.

Application of the Restricting Flow of Solid Edges in Fabricating Superhydrophobic Surfaces

Application of Superhydrophobic Edge Effects in Solving the Liquid Outflow Phenomena.

Superhydrophilic–superhydrophobic Patterned Surfaces: from Simplified Fabrication to Emerging Applications

Fabrication of Air-Permeable Superhydrophobic Surfaces with Excellent Non-Wetting Property

Fabrication of Super-hydrophobic Surfaces for Microfluidic Chips

Influence of fluid flow on the stability and wetting transition of submerged superhydrophobic surfaces.

Recent Developments in the Fabrication and Application of Superhydrophobic Suraces

A Liquid-pressure-adaptive Superhydrophobic Surface

Femtosecond laser patterned superhydrophobic surface with anisotropic sliding for droplet manipulation

From petal effect to lotus effect: a facile solution immersion process for the fabrication of super-hydrophobic surfaces with controlled adhesion.

Liquid‐pressure‐guided superhydrophobic surfaces with adaptive adhesion and stability

Robust Superhydrophobic Surfaces via the Sand-In Method

Multiple Liquid Manipulations on Patterned Surfaces with Tunable Adhesive Property

Design of robust superamphiphobic surfaces with enlarged area fractions: the considerable role of Laplace pressure in dynamics of contact lines

Asymmetric Jetting during the Impact of Liquid Drops on Superhydrophobic Concave Surfaces

Investigation and Application of an Ultrahydrophobic Hybrid-Structured Surface with Anti-Sticking Character

Fabrication of Hierarchical Structures for Stable Superhydrophobicity on Metallic Planar and Cylindrical Inner Surfaces

Enhancement of Water Repellence by Hierarchical Surface Structures Integrating Micro-dome and Micro-pillar Arrays with Nanoporous Coatings

Janus Fabric with Asymmetric Wettability for Switchable Emulsion Separation and Controllable Droplets with Low Friction

Large-area fabrication and applications of patterned surface with anisotropic superhydrophobicity

Fabrication of extreme wettability surface for controllable droplet manipulation over a wide temperature range