Abstract:In this paper, we tested the mechanical properties at room and high temperatures, and compared the cutting performance of three ceramic tool materials with different components added sequentially. By analyzing and comparing, the influence of material components on the changes in material mechanical properties and cutting performance is obtained, and the guidance for material system design is proposed. Three kinds of Si3N4‐based ceramic tools (single‐phase Si3N4, Si3N4/(W,Ti)C, and Si3N4/(W,Ti)C/Ni) were fabricated by microwave sintering. The phase composition, toughening mechanism, mechanical properties at room and high temperatures (800°C), and cutting performance of Si3N4‐based ceramic tool materials with different additives were investigated. The results showed that the addition of (W,Ti)C and Ni had a significant effect on improving the mechanical properties at room temperature, although it reduced the phase transition conversion rate of Si3N4. Si3N4/(W,Ti)C tools had good high‐temperature stability, while Si3N4/(W,Ti)C/Ni tools had a decrease of about 31.6% in high‐temperature hardness and a decrease of 13.7% in high‐temperature flexure strength. Under the premise of ensuring a certain level of fracture toughness, high‐temperature hardness is the main influencing factor on the cutting life of cutting tools. The Si3N4/(W,Ti)C tools exhibit superior cutting performance whose cutting life reaches to 50.67 min which was 1.37–3.27 times longer than the other two ceramic cutting tools at the same cutting parameters when continuous dry cutting T10A. In addition, high‐temperature flexure strength limits the choice of cutting speed, and lower high‐temperature flexure strength can lead to rapid tool failure.

Silicon Nitride Ceramic Cutting-Tools and Their Applications

Studies on Si3N4 Ceramic Cutting Tool Materials and Their Applications

Development and Applications of New Types of Ceramic Cutting Tools

Enhanced Performance in Si3N4 Ceramics Cutting Tool Materials by Tailoring of Phase Composition and Hot-Pressing Temperature

Microstructure and Mechanical Properties of Spark Plasma Sintered Si3N4/WC Ceramic Tools

Study on the preparation of hard and wear-resistant titanium nitride films on silicon nitride ceramic cutting tools

Virtues of the Silicon Nitride Ceramic Tools Reinforced by Nitride Particles

The applications of new ceramic cutting tools in machining of superhard materials

The influence of components on the high‐temperature performance and cutting performance of Si3N4‐based ceramic tools

Performance improvement of Si3N4 ceramic cutting tools by tailoring of phase composition and microstructure

Study on the mechanical properties, microstructure and oxidation resistance of Si3N4/Si3N4W/Ti(C7N3) nanocomposites ceramic tool materials

A Study on the Development of a Composite Ceramic Tool ZrO2/(W, Ti)C and Its Cutting Performance

Effect of Si3N4 Additive on Microstructure and Mechanical Properties of Ti(C,N)-Based Cermet Cutting Tools

New Progress in the Preparation and Application of High Performance Silicon Nitride Ceramics

Cutting Performance and Tool Wear of SiAlON and TiC-whisker-reinforced Si3N4 Ceramic Tools in Side Milling Inconel 718

Alumina ceramic tool material with enhanced properties through the addition of bionic prepared nano SiC@graphene

New Process for Improving Silicon Nitride Cutting Tools: Coating by Pulsed High Energy Density Plasma

Study of the mechanical properties, toughening and strengthening mechanisms of Si3N4/Si3N4w/TiN nanocomposite ceramic tool materials

Effect of SiC Addition to Al2O3 Ceramics Used in Cutting Tools

Preparation of Al2O3/Ti(C,N)/ZrO2/CaF2@Al(OH)3 Ceramic Tools and Cutting Performance in Turning

Cutting performance and wear mechanism of spark plasma–sintered silicon nitride ceramics tool in dry turning of 41Cr4 hardened steel