Abstract:Heavy Vehicles speeds and dynamic loads are critical factors to bridge’s structure fatigue and rapid deterioration. The proposed paper addresses the modeling and simulation of dynamic loads of heavy vehicles, such as trucks and buses, on bridges and the effects of their speed on frequency response. In light of the above analysis, this paper proposes a method on how to minimize the structural vibrational of the combined vehicle and bridge system using semi-active suspension control. The vehicle dynamic load is minimized through an optimization scheme to yield an impact force with negligible bridge lateral deflection. The dynamic coupling between the vehicle and bridge are studied by examining the modes that are most likely to be excited by the vehicle speed and the roughness of the bridge surface. The models consist of a bridge and a heavy vehicle. The bridge is modeled as continuos, lightly damped beam with different supports defined by the boundary conditions. The vehicle is a multi-degree of freedom (MDOF) system undergoing motion in one plane. The methods of solution consist of a simple supported beam that closely simulates the first three beam modes of the Kishwaukee Bridge in Rockford, Illinois. The surface of the bridge generates some random excitation that serves as input to the vehicle, this is commonly known as the roughness of the bridge surface. The heavy vehicle is moving from left to right of the simply supported beam. The system is analyzed and optimized by semi-active control algorithms. Close form numerical solution is obtained by a set of second order differential equations for the bridge-vehicle system. Experimental data obtained from the vibration testing of Kishwaukee Bridge (Illinois) were collected and validated with a FEM model. Only the first three beam modes were used due to the experimental limitations and the actual structural condition of the bridge. Using MATLAB a simulation is obtained by inputting the linear time-variant equations and optimizing the system. Simulations of bridge vertical motion under different dynamic load conditions were examined and the results of bridge structure response were analyzed by comparing the effects of passive versus semi-active suspension controls. The method shows effectively how we can reduce the dynamic load force magnitude and its frequency of impact. The latter is usually associated with structural damage caused to the bridge.

Effect of approach span condition on vehicle-induced dynamic response of slab-on-girder road bridges

Vehicle Induced Dynamic Behavior of Short-Span Slab Bridges Considering Effect of Approach Slab Condition

Dynamic Response of Bridge Approach Treated with Deep-Seated Concrete Slab

Vehicle Load-Induced Dynamic Performance of FRP Slab Bridges

Effect Of Typical Damages On Vehicle-Induced Dynamic Response Of Simply Supported Multi-Slab Girder Bridges

Impact effect analysis of bridge with simply supported concrete hollow slab subjected to action of typical heavy vehicles

Spatial dynamic impact effects of hollow slab bridge subjected to moving vehicle

Investigation and simulation of bump effects on vehicle-induced dynamic vibration of bridges

Vehicle-Induced Dynamic Performance of FRP Versus Concrete Slab Bridge

Dynamic response of continuous girder bridge under moving vehicular loads

Performance Evaluation of Existing Bridges under Vehicle Dynamic Effects

Dynamic Response Impact of Vehicle Braking on Simply Supported Beam Bridges with Corrugated Steel Webs Based on Vehicle-Bridge Coupled Vibration Analysis

Impact Effect Analysis for a Continuous Concrete Curved Bridge Due to Multi-Vehicle Loading

Development of Dynamic Impact Factor for Performance Evaluation of Existing Multi-Girder Concrete Bridges

Dynamic Analysis Techniques for Road Bridges Under Large Traffic Flows

Dynamic Performance of Strengthened Concrete-Filled Steel Tubular Arch Bridge Due to Moving Vehicles

Rigid–flexible coupled dynamic response of steel–concrete bridges on expressways considering vehicle–road–bridge interaction

ADVANCES IN WIND-VEHICLE-LONG SPAN BRIDGE INTERACTION

Effects of Heavy Vehicle Speeds on the Structure and Vibration of Bridges

Dynamic performance of a concrete-filled steel tube high-pier curved continuous truss girder bridge due to moving vehicles

Dynamic Performance-Based Assessment for Tied-Arch Bridges Subjected to Heavy Multi-Axial Tractor-Trailers