Abstract:Heavy Vehicles speeds and dynamic loads are critical factors to bridge’s structure fatigue and rapid deterioration. The proposed paper addresses the modeling and simulation of dynamic loads of heavy vehicles, such as trucks and buses, on bridges and the effects of their speed on frequency response. In light of the above analysis, this paper proposes a method on how to minimize the structural vibrational of the combined vehicle and bridge system using semi-active suspension control. The vehicle dynamic load is minimized through an optimization scheme to yield an impact force with negligible bridge lateral deflection. The dynamic coupling between the vehicle and bridge are studied by examining the modes that are most likely to be excited by the vehicle speed and the roughness of the bridge surface. The models consist of a bridge and a heavy vehicle. The bridge is modeled as continuos, lightly damped beam with different supports defined by the boundary conditions. The vehicle is a multi-degree of freedom (MDOF) system undergoing motion in one plane. The methods of solution consist of a simple supported beam that closely simulates the first three beam modes of the Kishwaukee Bridge in Rockford, Illinois. The surface of the bridge generates some random excitation that serves as input to the vehicle, this is commonly known as the roughness of the bridge surface. The heavy vehicle is moving from left to right of the simply supported beam. The system is analyzed and optimized by semi-active control algorithms. Close form numerical solution is obtained by a set of second order differential equations for the bridge-vehicle system. Experimental data obtained from the vibration testing of Kishwaukee Bridge (Illinois) were collected and validated with a FEM model. Only the first three beam modes were used due to the experimental limitations and the actual structural condition of the bridge. Using MATLAB a simulation is obtained by inputting the linear time-variant equations and optimizing the system. Simulations of bridge vertical motion under different dynamic load conditions were examined and the results of bridge structure response were analyzed by comparing the effects of passive versus semi-active suspension controls. The method shows effectively how we can reduce the dynamic load force magnitude and its frequency of impact. The latter is usually associated with structural damage caused to the bridge.

Effect Of Typical Damages On Vehicle-Induced Dynamic Response Of Simply Supported Multi-Slab Girder Bridges

Dynamic Behavior of Damaged Bridge with Multi-Cracks Under Moving Vehicular Loads

Research on damage identification of simply supported bridge based on effect size method for vehicle-bridge coupled vibration

Identification of Distributed Damage in Bridges from Vehicle-Induced Dynamic Responses

Assessment of Local Damages in Box-Girder Bridges Using Measured Dynamic Responses by Passing Vehicle

Identification of a bridge's structural damage and vehicular parameters based on dynamic response sensitivity analysis

Evaluation Index of Hinged Joint Damage for Simply Supported Multi-slab Girder Bridges Based on Vehicle and Bridge Coupled Vibration

Structural damage identification based on dynamic deflection sensitivity of bridge under vehicle loading

Dynamic response performance of bridge piers under non-bottom vehicle collision

Structural damage identification using vibration responses of bridge under vehicles with uncertain parameters

A Structural Damage Detection Approach Based On Response Sensitivity For Bridges Subjected To Moving Vehicles

Effects of Heavy Vehicle Speeds on the Structure and Vibration of Bridges

DAMAGE DETECTION OF BRIDGES BASED ON TRAIN-INDUCED BRIDGE RESPONSE AND SENSITIVITY ANALYSIS

Review on Bridge Structural Damage Identification Techniques Based on Bridge-vehicle Coupled Vibration Analysis

Dynamic Behavior of Damaged Concrete Bridge Structures under Moving Vehicular Loads

Vehicle Induced Dynamic Behavior of Short-Span Slab Bridges Considering Effect of Approach Slab Condition

Identification of Both Structural Damages in Bridge Deck and Vehicular Parameters Using Measured Dynamic Responses

Damage Identification of Simply Supported Bridges Using Static Responses: Unified Framework and Feasibility Study

Effect of approach span condition on vehicle-induced dynamic response of slab-on-girder road bridges

Evaluation of the Dynamic Impact of a Passing Vehicle on a Bridge Deck Due to a Damaged Expansion Joint

Simulation and Experimental Study on Bridge–Vehicle Impact Coupling Effect under Pavement Local Deterioration