Abstract:There are heat transfer correlations for heat transfer analysis in single tube geometries after several experimental and theoretical heat transfer studies in these single tube geometries. This is not the case for heat transfer analysis in rod bundle geometry with regard to proposed square fuel assembly of the Supercritical-Water-Cooled Reactor (SCWR) European Atomic Energy (EURATOM) design. Thus limited heat transfer studies exist on rod bundle geometry at supercritical pressures. Heat transfer correlations with accurate prediction capabilities of coolant and wall temperatures will be helpful in carrying out heat transfer studies at supercritical pressures. This paper presents the performance of twelve selected heat transfer correlations assessed on the 1/8th bare square fuel assembly of the SCWR EURATOM design using Simulation of Turbulent flow in Arbitrary Regions Computational Continuum Mechanics C ++ based code (STAR-CCM + CFD code). The obtained numerical results were compared with the results obtained by Waata numerical experimentation. Overall, the Cheng et al. correlation provided the most satisfying prediction for the wall temperatures in all the sub-channels and captured closely Wataa's Numerical data. The maximum wall temperature was obtained in sub-channel 9, the hottest sub-channel and exceeded the design limit 620 °C by 60 °C for the Cheng correlation. The difference in temperature between the hottest and coldest sub-channels 9 and 1 respectively was approximately 80 °C. It was found that Cheng correlation is best suited for heat transfer prediction in rod bundle geometry at supercritical pressures with regard to the proposed square fuel assembly of the SCWR EURATOM design. It was also found that the different numerical tools adopted for this study and Waata study were able to capture the trends of normal, enhanced and deteriorated heat transfer regimes normally observed at supercritical pressures. Nevertheless, experimental investigations involving rod bundles adopted in this study should be conducted to validate the results obtained numerically and address the inconsistency of the conclusions drawn when compared with Waata data and other similar studies.

Cfd Analyses in Tight-Lattice Subchannels and Seven-Rod Bundle Geometries of A Super Fast Reactor

Cfd Analysis of Heat Transfer in Subchannels of A Super Fast Reactor

Numerical Simulation and Analysis on Thermal-hydraulic Behavior of Fuel Assembly for Sodium-cooled Fast Reactor

CFD Investigation on Thermal-Hydraulic Behaviors of a Wire-Wrapped Fuel Subassembly for Sodium-Cooled Fast Reactor

Fuel, Core Design and Subchannel Analysis of a Superfast Reactor

Assessment of heat transfer correlations in the sub-channels of proposed rod bundle geometry for supercritical water reactor

Numerical Investigation for the Heat Transfer Mechanisms Between Subchannels of Bar Rod Bundles Cooled by Liquid Sodium

Effects of Circumferential Heat Conduction in Fuel Rods on Sub-channel Analysis for SCWR Core

CFD evaluation of turbulence models for flow simulation of the fuel rod bundle with a spacer assembly

Investigation on the Critical Heat Flux in a 2 by 2 Fuel Assembly under Low Flow Rate and High Pressure with a CFD Methodology

Subchannel Thermal-Hydraulic Analysis of the Fuel Assembly for Liquid Sodium Cooled Fast Reactor

Numerical investigation on critical heat flux for 5 × 5 fuel assemblies with a wide range of working conditions

CFD Simulation of Flow and Heat Transfer Characteristics in a 5×5 Fuel Rod Bundles with Spacer Grids of Advanced PWR

Sub-Channel Analysis Of Scwr Assembly With Double-Row Rods

CFD Simulation of a 61-pin Wire-wrapped Fuel Subassembly for Sodium Cooled Fast Reactor

Development of a Subchannel Analysis Code for SFR Wire-Wrapped Fuel Assemblies

Thermal-hydraulic Analysis of a 7-Pin Sodium-Cooled Fast Reactor Wire-Wrapped Fuel Bundle

Single-phase Flow in Helical Cruciform Fuel Assembly with Conjugate Heat Transfer

CFD analysis for full vessel upper plenum in Maanshan Nuclear Power Plant

Numerical Simulation of Compact Fuel Assembly in Fast Reactor

Flow Blockage Analysis for Fuel Assembly in a Lead-Based Fast Reactor