Emissions of PM2.5-bound Polycyclic Aromatic Hydrocarbons and Metals from a Diesel Generator Fueled with Biodiesel Converted from Used Cooking Oil
Jen-Hsiung Tsai,Shui-Jen Chen,Sheng-Lun Lin,Kuo-Lin Huang,Cheng-Kai Hsueh,Chih-Chung Lin,Po-Min Li
DOI: https://doi.org/10.4209/aaqr.2019.04.0204
2019-01-01
Aerosol and Air Quality Research
Abstract:To elucidate the characteristics of fine particulate matter pollutant emitted from a diesel engine, a fossil-based diesel fuel (D100) and two blended fuels consisting of D100 and waste cooking oil (WCO) convered biodiesel (W) are tested with a diesel engine generator at loads of 1.5 kW and 3.0 kW. The blended fuels contain 20% and 40% W and are referred to as W20 and W40, respectively. The PM2.5 emissions and their polycyclic aromatic hydrocarbon (PAH) and metallic components are investigated. Experimental results show that higher concentrations of PM2.5, PM2.5-bound Sigma PAHs and Sigma metals, and Sigma BaPeq are generated at the 3.0 kW load, with its greater fuel consumption (FC), than the 1.5 kW load. Additionally, of the three fuels, using W20 emits the lowest concentrations of PM2.5, PM2.5 -bound EPAHs, and Sigma BaPeq. Specifically, the reduction in Sigma BaPeq mainly results from the effective inhibition of HMW-BaPeq. Conversely, when using W40, the PM2.5-bound Sigma metals significantly decreases, and its composition is strongly affected by the metallic content in the fuel. Although W20 and W40 exhibit higher FC (3.0% more) and brake-specific fuel consumption (BSFC; 3.1% more) than D100, they generate lower concentrations of PM2.5 (18.1% less), PM2.5-bound Sigma PAHs (22.8% less) and Sigma metals (22.0% less), and Sigma BaPeq (35.0% less) at both engine loads. The emission factors of these pollutants in the engine exhaust are also reduced, particularly at the higher load (3.0 kW). Accordingly, WCO based biodiesel additives may decrease the PM2.5, PAHs, and metals exhausted by diesel engines, thus reducing the BaPeq of these emissions.