Performance and emissions of neat crude palm oil and its emulsions as diesel engine fuel
Arif Fahim Ezzat Chan,Wira Jazair Yahya,Hasannuddin Abd Kadir,Nik Rosli Abdullah,Ahmad Muhsin Ithnin,Yahaya Hawari,Dhani Avianto Sugeng
DOI: https://doi.org/10.1002/ep.13749
2021-09-02
Abstract:The depletion of petroleum diesel has prompted the use of biofuels and other alternative sources of energy. The direct use of neat Crude Palm Oil (CPO) has mostly resulted in the increase of Oxides of Nitrogen (NOx). Emulsification has demonstrated the capability of reducing NOx emissions. An experiment is conducted to investigate the effect of increasing water content in CPO. Water-in-CPO emulsions with varying water contents by volume (5%, 10%, and 15%) with 1% SPAN 80 surfactant are labelled as W5CPO, W10CPO, and W15CPO. The fuels were tested on a single-cylinder diesel generator at 2,900rpm and 3,200rpm with varying electrical load. For all load conditions at 3,200rpm, the smoke opacimeter reading is highest at 35% with W15CPO and the lowest smoke reading is 15% with W5CPO as fuel. The NOx of CPO was higher than ordinary diesel up to 29% at lower load. The NOx emissions of the CPO was reduced when the amount of water was increased. The maximum reduction in NOx of W15CPO was 66% whereas the minimum NOx reduction was 31%. At 3,200rpm and 4kW, the CO emission of W5CPO was 21% lower in relation to CPO. The W5CPO showed a different trend in the exhaust emissions compared to Water-in-CPO emulsions with higher water content. Overall, emulsification has the potential to reduce NOx emissions in relation to neat CPO.This article is protected by copyright. All rights reserved.
environmental sciences,green & sustainable science & technology,engineering, environmental, chemical