Comparison of Emissions from Common-Rail Engine Fuelled with Fischer-Tropsch Diesel, Conventional Diesel and Their Blends

Zelong Fan,Jinou Song,Gang L,Chonglin Song

DOI: https://doi.org/10.11715/rskxjs.R201305012

2013-01-01

Abstract:This paper describes the experimental results of a common-rail engine fuelled with Fischer-Tropsch(F-T) diesel, conventional diesel and their blends. Both regulated and non-regulated emissions were measured in order to exploit at the best the synergies between the engine technology and the fuel properties. Experiments were performed in European steady state cycle(ESC) and load-characteristic modes. In load-characteristic modes, the tested engine was operated at three speeds, each with four different engine loads. The experimental results showed that the NOx emission benefit of F-T fuel was more evident at high speed and high load, and larger benefits of HC and CO emissions were obtained at the idle operating point and low-load points. Reduced particulate matter(PM) emissions were proportional to the F-T fractions in the blends, while a 50% or 30%blend of F-T could produce the same gaseous reduction as the neat F-T fuel. PM emission reductions with F-T fuel and its blends were more dependent on engine operating condi-tions than gaseous emission reduction. The PM benefits were more evident at high speed and low load. The reductions of the mean particle diameters were almost proportional to the amount of F-T in the blend. The particle size distribu-tions were wider and the total particle number concentrations were larger with blends than those with neat F-T fuel or diesel fuel.