Abstract:In the sheet forming process, the final bending angle is mostly determined based on experience rather than based on a reliable theoretical framework. Furthermore, the local bent areas tend to decrease in thickness. Thus, it is difficult to control the quality of the final products. In this study, we developed an optimized bending angle function by combining segment boundaries to improve the final sheet forming quality and reduce the local thinning defects. The finite element submodel method was used to establish a high-definition thickness-sensitive numerical model for the bottom bending area of the hat-shaped part. This method accurately simulated the thickness variation law of the bending area of roll forming and analyzed the optimization function of the bending angle of the segment boundary as well as the process parameters for local thinning. Finally, roll-bending experiments were conducted to analyze the bending angle distribution conditions and the change law with respect to the process parameters of the cap-shaped parts in case of local thinning defects to verify the accuracy of the finite element simulation process. The results showed that the local thinning defect in the bending area of the hat-shaped part was smaller during roll bending, and the forming quality obtained was better than that obtained using other previously reported methods. The experimental data were consistent with the simulation data, verifying the accuracy of our proposed approach. Moreover, the thickness of the thinning defect was influenced by the process parameters; the plate bending radius and yield strength increased, and thickness thinning gradually decreased. Furthermore, the local thinning defects increased with the increasing plate thickness.

Surface quality control method for 90° bending products in progressive die

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Research and Application of Edge Plane Shape Control Method of High Grade Pipeline Steel

Control of Hot Bending Accuracy and Surface Quality for Inconel718 Thick Plate with Gradual Changed Curvature

Analysis of Forming of Automotive Drawbar and Design of the Die

Improvement of Die-Roll Quality in Compound Fine-Blanking Forming Process

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Experimental and Numerical Study on Surface Damage of Dual-Phase Steel Sheet During Stamping

The Composite Die Design of Bending Flanging

Method of Surface Defects Control by Tool Surface Compensation for Exterior Auto-panels

Impact of bending dies with different friction forms on forming force and quality of tubes manufactured by free bending technology

Study on quarter-wave control of DP980 steel based on a bending force linear combination strategy

Approach Based on Response-Surface Method to Optimize Lining of Dies Used in 3D Free-Bending Forming Technology

A New Approach of Die Shape Optimization for Sheet Metal Forming Processes

Effect of discrete roller dies on the contour accuracy of profiles in multi-point flexible stretch-bending forming

Research on Progressive Die Design for Asymmetric U-Shaped Contactor

Influence of bending angle function on local thinning defects of roll-formed sheets based on segmental boundary combination optimization

Research on the Mechanism and Processability of Roll Forming

Effect of Flexible 3D Multipoint Stretch Bending Dies on the Shape Accuracy and the Optimal Design